Find trusted local electricians in South West Sydney

I need to integrate a 5.1kwh Portable Power Station battery to my home (granny flat) in order to run my light, power plugs and my stove top. I need change over switch(es) to alternate as desired between the Portable Power Station battery unit and the utility power supply (circuit breaker box). I’ve marked the proposed location of the wall mounted change over switch(es) "A" in the photo (it's located adjacent to the circuit breaker box located in the kitchen cabinet marked "B"). Bluetti sells various power cables, 1 of which will no doubt be needed to connect to my granny flat circuit breaker box. Ideally you will propose a practical solution in order to ‘plug in’ (connect) the Portable Power Station battery to the granny flat circuit breaker box (lights, plugs and stove top). For your information, the unit is a Bluetti EP500 Pro. I recharge the unit via movable solar panels not via fixed roof mounted solar panels. Any advice and information welcome and much appreciated. If this is a job for you please reach out to me. Thank you.

The lcd display of my electric bike is burnt out probably due to some water going inside. As the display is not working, none of the electric components are working and as a result it is working as a normal bike. If the electric components can be restored again that would be perfect.

Glass intact mechanisim go up down broken

looking to wrap my van as an electrician

Need a replacement led light outdoor & new switch

Additional power point behind TV. There is already a power point above the skirting

I need some electrical work done at my hose

I need a handyman with an electric saw to cut the legs of my bed base.

Require a GPO and Antenna outlet to be relocated horizontally on a wall. There is a frame unit that will be going up on the wall and the supplier requires the GPO and Antenna to be within 'safe zones' - pictured. Currently the GPO and Antenna is sitting outside the safe zone and they need to be brought in closer together. Refer to image for instructions.

A part of the house is without electricity due to the rain. Please restore power supply.

I need about 10-20 downlights installed and old ones replaced. Do not have lights.

I need to replace my garage batten light. roof heigh is 340 cm so need ladder. its strata property. I already bought a light.

Replace two broken electrical outlets

I have 25 standard wall power outlets that I need replaced with smart wifi ones, I will provide the new ones Similarly I also have 27 light switches that I need to be replaced with smart wifi ones again I will provide the smart wifi light switches Finally, I need you to make 3 new power outlets in the bathrooms behind the led mirrors, for each one there is an existing power outlet about 40 cm away About the location: this is a residential house built about 15 years ago, neutral wires do exist (I understand this is necessary for the new outlets to work) the walls are gyprock About the new outlets: the manufacturer has shared SSA approval certificates to confirm compliance with Australian electrical code, I do notice though that the terminals are all about 1-2 mm smaller than the standard HPM installed currently, I also noticed that they are closer to each other as per the pictures attached to the job. These were purchased locally and have a warranty, I do understand that they won’t work with 2 way lights and that’s fine About you: you must be a certified electrician who is willing to share his credentials and provide an invoice, as this is my residence naturally safety is paramount - I understand of course you can’t give a warranty on the equipment since you will not be providing it

Electrical work needed need it done soon

I need downlights installed in my house, roughly 30 could possibly be more. Please let me know if you need photos. Install only. I'm happy to supply them.

Nbn box installed in garage. Internet modem approx 20-25 m away in the house. Ive been told i need an extended ethernet cable to connect the 2

Install a new light. All equipment supplied and replaced a power point.

Install smoke alarm, we don’t have the smoke alarm so we need that included

Need to isolate power points etc in walls that are being removed. Price can be determined upon site visit