Find experienced local carpenters in Inner South Melbourne

Handyman, builder or brickie required to install subfloor door like the one in the photo ( taken from Bowen's site for a gal door). Cost to include supply and install

I am seeking assistance in installing a garden shed for my carport storage unit. My initial budget is $100, but I am open to discussing your preferred pricing and negotiating from there. Please provide me with your best offer and let's find a mutually beneficial solution.

Restore 8 panels Folding Timber Doors Frame around Heater Chair PREPARATION Sand/Strip To Bare Timber, Chemical Timber Rejuvenation, Fill Timber Cracks With Wood Colour Putty, Light Sand And Prepare For Oiling Apply 2/3 coats of oil

I need someone to cut a ~4.2 degree on the end of a piece of structural pine timber. See photos but the piece of the timber is 2.7m X 90mm X 45mm

I have the kickboard and filler panels already so no materials are required. All filler panels need to be cut to width and installed and all kickboards need to be cut to length and height (between floor and base of cabinet) The following fillers are required: - 1 x base cabinet filler (next to 150mm cabinet) - 1 x pantry filler - 1 x wall cabinet filler - kickboards in U-shape for kitchen (3 lengths between 2 end panels) - 1 x kickboard under pantry

We’ve got a hole cut out for an induction stove top but turned out that it’s slightly too small for it to fit. Need someone to cut it a bit more.

Removing old cabinets, making and installing new cabinets in the kitchen

We need assistance closing off an open space in our living area and converting it into a bedroom. As shown in the photo, the wall needs to be extended, and a new door must be installed. The length is approximately 1940mm, and the door (including the frame) is expected to be around 980mm. The area will also need to be painted. We are happy to pay for materials separately if that is easier. Please specify in your proposal whether the cost includes materials or not. I am keen to complete this task as soon as possible.

Hello, Looking for a cabinet maker in the Bayside area who can help install a brand new replacememt underbench pull out bins in our kitchen as shown in the photos, I have already removed the old one but need someone to reinstall to correct specs. Please message for more information.

We have an EasyShed bike shed that I need built. All pieces and instructions ready to go.

Water damage to ceiling in 6 places. Most of it mild and probably just needs stain blocking and painting. One spot might need replastering (last pic). Already have left over ceiling paint.

I have put together the 4 walls of a garden shed already. I just need someone to screw the corners and the roof on and bolt it into the brickwork to secure it. Estimate it’s about 1.5hr work tops.

We need to fix the spot with the hole with a cover that looks like in the 2nd image. Please quote for labor + wood and advise if you could source a wood that will look similar.

See photo attached for reference. Chest is already built. However, it is currently shaky and wobbly, unsure why. The job is to fasten and make sure everything is tight ans secured, will only release funds once it is in that state. All manuals and associated parts are available.

Need a cabinet maker make some overhead cupboards and broom cupboard with built in desk as pic.. wall is 2850mm wide and 2700mm high

Install three pre-built kitchen cabinet frames in kitchen on brick wall. Old cupboards will be removed Must have own equipment and supplies for brick installation and must be experienced hanging on brickwork. Hung on mounting bracket, 2m bracket.3mm back No side panels Also cutdown bench top to fit lower cabinet bench top just for the new space.

I need a new external entry door to the garage installed. Existing door will need to be removed, have the existing knob/lock taken off, bew door to be installed and painted with a good quality external white paint, and knob/lock placed in. Also require disposal of current door. Details on the new door can be found here: https://www.bowens.com.au/p/corinthian-2040x820x40mm-external-door-halflite-no-7a-exp-primed-clear/ Pictures are attached of the existing door to be removed. You can see that the inside door frame is currently grey, but I would also like this painted white. I will reimburse for all paint prior to job commencement and when receipts are provided.

Need a custom merbau screen panel built and installed to cover the exposed pipe (pipe needs to stay where it is) and fence area. 430 long 200 high With small cut out at the end to go over the down pipe and boxed in at the other end. Photos provided to give an idea but please ask for more details as needed. Quote to include all fees including airtasker, materials, build and install.

3 bedrooms and a small connecting area. Photos are wide angle so looks a bit larger than actual.

I need a laminated panel cut to size and two holes cut out for fitting in an oven and microwave