Find experienced local fencing contractors near you

We have a bougainvillea creeper and the metal posts have rotted and snapped. We'd like to get them replaced to keep the creeper going.

We are wanting our current timber fence pulled down and replaced with color bond fence with concrete sleepers underneath. Also wanting side gate pulled down and replaced as well. Offer is only to be able to post the task, wanting you to come quote and then we can sort out a price.

I have two panels of Stratco Quickscreen to be installed at 90 degrees to each other adjoining an existing timber fence. The site is sloping and will require 3 post holes to 600mm. We need to screen neighbours bins. I will provide all materials

I need 2 x identical garden gates installed in my front courtyard. They are 1800mm high x 900mm wide & the wall openings are 1000mm wide, so will need timber to fill gaps (you to source & supply). I already have the hardware (hinges & latches), which also need to be installed. Require proof you've done this sort of thing before.

I am looking for quotes to install a rendered boundary wall at my property. Either blueboard or brick depending on price. "Budget" on this ad is not actual budget, as I dont have much idea of how much it will cost, hence requesting quotes. Approximately 27 lineal metres, 2m height (red line on image below). Will need letter box built in, and approx 1.8m area where gate will go (blue line; I am unsure how to finish this section over existing concrete path).

GARDEN EDGE CUT 30 MILLIMETRES OFF THE BRICKWORK GATE POST TIMBERS CUT OFF APPROXIMATELY 160 MILLIMETRES ABOVE GROUND LEVEL.

Repair small concrete pillar and fence in front yard. See pictures. 1 picture is from street view before the damages.

I am after a possum/wallaby proof fence around my veggie gardn. Roughly 5mx10m

Side gate latch and hinges were damaged by strong winds and need fixing.

To dig holes for fence posts

Fix my fence it got came off because of heavy wind

Install the front gate - Gate will be supplied just need installation and concrete to be poured. Cash in hand job no need invoice Quotation only by guess

full height fence approx 2m long Abolish existing pine log posts & boards Install new posts and clad my side, leaving other side to neighbours garden ready for them to do what they want. A painted colour masonite board behind vertical timber battens on my side.

I’m looking for someone to build a garden fence (just the wooden part), similar to the one shown in the attached picture. The fence will have 3 sides, and the measurements 6M each. Will supply all the materials required

We have just moved into a new house and the developer did not replace the old fence at the back of the property. It’s a shared fence with a neighbour directly behind. We have discussed with them that we will clean and spray paint it to match the side fence. Please quote me for this - fence is 9m long, about 1.6m high. Thanks.

Various handyman tasks Re Attach screen fence, straighten garden fence & inc paint touch up around property

Hello I need some general gardening, installation of reticulation and also I would like wires to be installed on all my fences so I can train star jasmine.

The Vertical Garden Feature weighs approximately 10 -12kgs, There is a chain attached. It needs to be secured to the upright fence posts as per the fence picture. The old bamboo screens to be detached from the rear fence and the two new ones fixed.

The timber garden gate urgently needs repair. The supporting post at the base has become loose, and the central post shows a large crack in the wood. As a result, the gate has fallen over. Immediate repairs are required to secure the loose post and either reinforce or replace the damaged central post to restore the gate’s stability and functionality.

Need repair of metal garden gate latch. Gate is operational but latch needs fixing/replacement. Job requires drilling. Looking for quotes - gate located in Kingswood.

Make a proper door for dogs between 2 unit .

we have a family members dog stay with us from time to time and we need a gate at the foot of the external stairs and a fence and gate of about 2 m to the side of the house. The construction needs to be such that the gate can easily be removed and stored elsewhere, simile the fence and gate when the dog is not with us so this probably needs to be of metal construction as it is lighter than timber.

Job Details: • Fence 1: Straight panel, approx. 1.5m wide • Fence 2: L-shaped, approx. 2.4m x 1.2m • Each enclosure needs one entry gate • Must include painting/staining in light natural timber colour (we can provide paint/stain or reimburse if needed) • you need to buy materials • Installation to be done at our premises (address will be shared with the assigned Tasker) Requirements: • Experience with timber fencing or carpentry • Must bring your own tools • Attention to detail and clean workmanship • Must complete both enclosures securely and safely for pets

Looking for someone to come and build my dog pet enclosure, it is already supplied and here

I am getting a new dog and need to add small gates 1 preferably and some mesh or net at bottom of one existing gate

Build an enclosure for dog * Fencing [ colour bond ] * Fences blocking each side of house and stairs * All doors of Fences must have self locking lock * Install roof of enclosure *The whole fence around yard needs to be blocked at the bottom with timber or bricks

Looking for a handyman to build a pet fence and gates for a small areas beside our house. We have a gate that also needs to be repaired.

Drill bracket extensions onto fence .

We are applying for a permit with the council to get a front fence installed. We have a heritage overlay properly so council approval is required. Our original application was declined and noted that we require: 1. A site plan showing the location of the current boundary fence and the location of any proposed boundary fences, including front fences. 2. A revised 1:50 elevation of the proposed front fence, showing: A) Dimensions, including posts, pickets and spacing between the pickets; and B) The proposed colour and finish. We have quotes from some fence companies we can share to support with this mock up for the council. Please advise if you need more detail.

I need someone to put up a catnet on the fence as per photo I have all the materials just need it put up. Im open to offers so keeping the budget low on here

There is a 2-3m gap in fence, one .5M and another by side of house that need dog proofing. Supplied steel posts and chicken wire. Photo shows part of fence already there and the gap. Cushions on gap. Flexible timing but prefer sooner rather than later.

I need to get an in ground dog wired boundary fence installed around our house yard approx 300m total

Hoping someone “handy” can come up with a budget friendly solution to dog proof the bottom section of my fence (it’s a rental). Needs to be aesthetically pleasing also. It’s about 8m long and approx. 15cm gap underneath. Will pay for whatever is needed from Bunnings etc plus your time. I need done ASAP as we can’t use the front yard until it’s secured. I’ve entered a nominal amount in the budget area until we have a better idea of options. Task needs to be undertaken after 12pm. Cheers

I need someone to go and take a look at a dog trailer that's sitting in my friends driveway to see what needs to be repaired on it so that it can be towed back to my place in Campbelltown. I would then like that same person to do the repairs and the towing back in the following days but this task is just to go and look and see, we will sort out the rest once we have connected :) It is a 4 berth dog trailer and unfortunately i don't have a photo of it. I believe that all that is wrong with it is it has a flat tyre that will need replacing

I have Houdini dogs and have just noticed that a fence panel is loose. Need the panel fixed - doesn’t need replacement.

Looking for metal fabrication who can build a pedestrian gate to be installed in an existing fence. - Two 100mm post on each side - Gate 900mm width 1.5meter height - Powder coated colour Deliver and install . Gate to be installed in a section where existing fence has damaged slat. Refer to pictures attached for colour.

I am looking for someone to reinforce my wooden fence so a dog cannot dig under it. This will require digging down and installing reinforcement (with wood or wire/mesh) attached to the fence. There is about 7m of fence to do. I am happy for you to come inspect and quote in person. Please quote inclusive of materials.

I have about 20 holes in Brushwood Fencing that I need patched. The holes are caused from dogs and foxes. I need the holes patched with brushwood or alternative. The Patch only needs to last about 12 months until the entire fence is replaced. Attached are some example photos. Job in West Pennant Hills

Two gates need fixing where rust has broken metal fence

I need a fence with a person gate built across my driveway to block off the backyard. My DIY setup fell down, need someone who knows how to build stuff. I’m in a rental so need it to be easily removed with minimal damage to the house. I have wooden lattice that can be used. I also have a rough plan in my head. The second part of the job is to block off under the house access to the front yard, again to stop my naughty dog escaping. The budget I’ve entered obviously depends on materials required, so super open to discussion! Estimated 1-2 hours work.

Need to replace old wooden fence with Colorbond fence about 20 meters long

Colorbond fence to replace old pickets....! 41.2 metres long about 1.85 m high Separate price to tear down existing pickets & take away Waste. + one stump removal...!

Need someone to remove half of existing colourbond pergola ( Upto the first row of horizontal piers) and install remaining pergola at back of GRANNYFLAT ( understand new posts needed will supply . Also remove colour bond fence in photos and reinstall 2metres back of position Can supply any extra materials needed just need labour using what we can with what we have

43 meters colour bond fencing and side gate 1.5 m , removing old low wire fencing

Looking for someone to do colourbond fencing and pool fencing Colourbond fence at the back with single pedestrian gate , double gate on one side of the house and sigle gate to the other side of the house . Pool fencing with a gate to the top of retaining wall

We are looking for quotes for a 8.3m Colourbond fence with a 2m gate for a backyard

Hey everyone, I need someone to install colorbond extension into an external wall, on the bottom of the wall for granny flat All the way into the walkway boundary

Colourbond Fence needs to he installed, dispose and remove old fence( if possible) or just remove. 1 Gate, all materials supplied need a labour only quote roughly around 8-10 l/m. Happy to help with labour and have all tools aswell if needed. Happy for day rate/ hourly/ total job cost labour only or supply and install for whatever needs to be done. Available for site visit anytime.

Colorbond fence gate collapse after strong wind. Reuse existing frames and sheets since it is still in good condition. Screws all gone and need to be replaced. Reattached the gate.

leaning colourbond fence

Hi, I’m looking for someone experienced in bricklaying and fencing (Colorbond) to inspect a boundary fence that’s currently being rebuilt between our property and the neighbour’s. The rebuild includes both a brick base and Colorbond panels. The job was arranged between the neighbour, my brother, and my ex (carpenter) — but I wasn’t part of the agreement or planning process. Now that the work is underway, our side looks: • Mismatched (bricks don’t line up or match existing ones) • Uneven and rushed compared to the neighbour’s • Potentially unsafe or not up to a proper standard I’d like someone to: • Inspect our side only (no access to neighbour’s required) • Check for any faults: poor alignment, uneven footing, rough bricklaying, etc. • Let me know if the job was done fairly, safely, and up to standard • Provide a short written summary + photos for documentation This is for peace of mind and clarity, so I can decide what to do next if necessary. Need someone flexible with timing, even if workers are still on-site. Budget: $60–$100 Open to offers within this range depending on experience & detail level. I’ve attached a couple of photos for reference — not the full job, just key sections to highlight visible issues. The rest has been left out to protect privacy. More details can be discussed after acceptance.

One of the colorbond fence panel flew off during cyclone Alfred. Fence panel needs to be reattached. I do not own a ladder

Need the fence removed and new fence built, hopefully in one day as the fence divides 2 units. The colour bond has to match the other fences in the complex in colour and style.

Remove colour bond fence and stack neatly Fence is to remain on site stacked neatly You will need a ladder and a battery drill/driver to remove screws

Need infill sheet replaced for colorbond gate. 2.8m W x 1.8m H. Install drop bolt, safety latch keyed lock. Gate to be raised by 50-60mm while refixing. End posts, stiles, frames etc are all reusable.

Supply and install new Colourbond fencing, approximately 1800mm high. Colour: Surfmist (posts and rails also Surfmist). Include timber sleeper (200x50mm) at the base. Complete removal and disposal of the existing damaged fence (partially broken due to recent cyclone - photo attached for reference). Site clean-up after completion. We have received a quote of $4500 for this work (including $500 for rubbish removal). The contractor who provided is busy and cannot make it in the next few weeks and hence reaching out to Air Tasker. Please provide your best quote. Thanks for your consideration.

30 metre of colour bond fence installed and supplied (1800 high in monument)

Build a colorbond fence - along side of driveway on boundary. 5.7 m x 1m (approx). A safety fence to be bolted onto a sloping concrete driveway. I would like the job completed by end April 2025. Please contact me with your offer and some information on other similar jobs you have completed.

Just need a colour bond fence to be built with roughly 3m length, 1.6m high and to match cream panels and red trim

Hi there – please see pics attached! I want to match my left-hand front fence to the right. This would involve: 1. Relocating the ‘sloped’ panel to the front. 2. Replacing the 4 x existing panels with higher ones. The dimensions of the panels I want to replace my current ones with, are approx.. 187cm high and 237cm wide. See pic attached/below!! *note: I have since had an arborist remove the overhanging branches in the pics, so there is clear access to install now. ****happy to discuss costs, $1k is just placeholder****