Hire a trusted alternator replacement service in East Brisbane

The function of the alternator is simple: supply power to the battery and keep the electronics running. Otherwise, your vehicle will stop working. Your car will send a series of signals that will indicate a failing alternator, including a whirring noise coming from your engine and the smell of burning rubber. If you're starting to notice these warning signs, then you may need to get your alternator replaced immediately. 

Mobile Alternator Replacement
At Airtasker, you can find trusted alternator specialists and other mobile mechanics near you, offering you a convenient way of repairing your car's alternator or replacing it as needed. You don't have to risk fixing it yourself or stress over finding a car repair shop in your neighbourhood. Your mobile alternator replacement specialist will go where you are and replace your car's alternator in no time.

Disconnecting the Battery

Before the actual replacement, your Tasker will first disconnect your car battery for safety purposes. Skipping this step might trigger a live wire as they're removing or replacing the alternator, and can cause further damage as well. They will only remove the negative cable while the positive one remains attached.

Removing the old alternator
Most alternators are usually found on top of the engine. Some alternators, however, are positioned deeper in the engine and removal might take a little longer. After locating the faulty alternator, your Tasker will detach the serpentine belt or v-belt, as well as the bolts, wirings, and cables connected to the engine. After which, the old alternator will be safely removed.

Inspecting the new alternator
Your new alternator must have the same mounting holes and wire connectors as the old one. If you're hesitant or worried about buying the wrong alternator, you can always arrange for your Tasker to help you find the right one for your vehicle.

Positioning and Installing the Alternator
Your specialist will install the new alternator where the old one was placed. This process is simple—match the bolt holes, then put the battery, serpentine belt, cables, and wirings back to where they were previously. Your Tasker will then turn on your engine to check if the replacement alternator is working correctly. You can also request for a quick test drive to make sure that the process was successful.