Hire trusted appliance installation services in Inner South Melbourne

Retaining ring has come out of the washing machine door seal and unable to get the door sealed again properly - doesn’t appear to be damaged just needs to be reinstalled

Remove mount from previous drying frame and install new one

Need an arlo 2k video doorbell installed at front door Ideally hard wired in by electrician. No previous door bell, so wiring would need to be new

I need two Ring Floodlight security cameras installed at my house. I already have the cameras. Wiring is not in place.

Remove the old dishwasher and install the new one at Bonbeach property. Then, take the old dishwasher and install it as a replacement for the old one at the Frankston North property.

Need washing machine installed. Pipe cannot be screwed on fully to the tap fixture which is causing a leakage.

Need to drill a hole between cabinets for the hose and install the washing machine.

I am looking for technichian who install gate motor. Not sure this is right place but lot of tradies here. When we got the house a few eyars back the motor is not working but we want to install a new motor with parts, ground track.. the gate is good con but all the old parts need replaced with a new motor. I am llokign for a reasonable and negotiable price if anyone does them here. I atatched the photos of my gate

uninstall a kitchen in a home that is within 10km of the new home, then re-install the same kitchen. i will also help carry, uninstall and reinstall to make it easier and quicker. the person needs to have access to a large van / truck to move the kitchen please, technical know how to make sure the kitchen is correctly installed with stone, rangehood. not sure on price so please make an offer and confirm best date for you.

Hi, I have a Battery Ring Video Doorbell and need it installed onto brickwork. I don't have a drill that can go into brick so need someone to help install it as per this https://www.youtube.com/watch?v=A45SGV5N7KY Should only take a few minutes! Thanks

In need of someone to install water pump and fan belts to a 2010 suzuki swift - manual. We will supply parts just need labour. We also have ramps and the car can be driven up into.

I need someone to remove an old oven, cookyop and rangehood and install the new ones i have purchsed.

The washing machine needs to be connected as a priority. Even if the machine stays where it is until a solution is found to adjust the cabinetry. The water valves require adjustments to accommodate the bulky end of the water hoses. See photo. The width of the washing machine will fit however it’s too high to slide under the bench. Open to solutions to alter cabinetry to make it fit. ie lift entire bench? Cut marble and stack them? Any other ideas? I do have the stacking rack unit as it was stacked in my previous home.

I moved into an 8-year-old house and have two small jobs. 1. My washing machine hose needs to be attached to the waste output. 2. I want my new fridge attached to the installed tap. Samsung only supplied a ‘standard’ attachment on delivery, and it doesn't fit our fridge tap. I would like someone with appropriate experience to do these small jobs correctly and source the required parts, which I will reimburse on top of fee (with receipts).

Simple range hood installation Already have the range hood and the electrical point has already been roughed in.

We have bought all the equipment to install a water system in our front and back gardens (each about 5 x 5 metres) and we'd like someone to install them please

Hi All, Need someone to repair Haier 6kg Washing Machine HWT60AW1 Top Loader. It’s showing error E1 and is not draining. Pipe seems clean from what I can see. Hoping someone can come today. :)

Replace two hardwired smoke alarms interconnected

Moved house and fridge doors were removed, now with fridge being reinstalled have been unable to work out the reassembly of brackets/hinges and electrical cabling. Have bought new parts for job, it’s mainly the reconnecting of cabling that needs attention. Fridge in place and working.

Attach vent adapter to rear of dryer and attach vent hose to ceiling. All parts ready.