Hire a trusted appliance repair service in Belgrave

There is a Electrolux washing machine that is not completing the final part of the spin cycle and show error 20. The door handle is also broken but I have got a spare door handle to be replaced. Then there is a fisher & pikyle dryer that is powering on but not spinning and competing the dryer cycle. Please see photo attached please.

Renault Zoe heating/cooling fan is not working. I've replaced the Heater Control Module and checked the fan is physically OK but now run out of diagnostic knowledge - Due date: Flexible

My double door fridge appears to not be cooling well, and I cannot seem to get it lower than 9 degrees even though the temperature is set to 4 degrees. Model details provided in the attached image. I am looking for someone to visit and hopefully repair the fridge. Please provide some detail in your offer as to what kinds of checks you think you can do to see what's wrong with it. Thanks - Due date: Flexible

My cricut explore air 2 is having issues cutting correctly. When it cuts a circle one side will cut all the way through and the other side will not (based on direction blade is traveling). The circle will also not connect accurately at the top. I have contacted cricut and tried their trouble shooting. But as my machine was a few months outside of the warranty when I reported the issue, I’m not covered. Happy to bring machine to you for repair Must have prior experience repairing cricut machines. Amount is placeholder. Please quote amount for looking at my machine to diagnose issue (since I understand you will not be able to give an idea of price before then) - Due date: Flexible

Motor running but not cooling. One-door Hoover fridge (includes freezer compartment). - Due date: Needs to be done on Thursday, 22 December 2022 or ASAP

We need a treadmill.repaired. it makes a whining noise which makes it unpleasant to use. Can you please advise approximate cost for this repair. - Due date: Before Saturday, 31 December 2022

Dishlex model DSF6205X is showing .30 error and requires repair - Due date: Needs to be done on Thursday, 23rd Dec 2021

I have a Tunturi T40 treadmill displaying E1 error message. I have followed all online troubleshooting guidelines with no success. The type of E1 error that occurs is: treadmill momentarily starts turning (0.1 of a second), then stops immediately and a few seconds later, the E1 error message flashes on the screen. Upon opening the unit up and viewing the circuit board, the main power light turns on (indicating normal and full power supply); and then when I start the treadmill, after 0.1sec, both the ERROR ledlight turns on fully, remaining fully lit...AND also the FAST led light flickers rapidly for 2x sets of a couple of seconds, and then turns off, but the ERROR light remains on. Upon turning off the main power switch at the rear of the treadmill, a 'click' can be heard from the main circuit board (I'm guessing a re-set of some sort).