Hire a trusted appliance repair service in East Melbourne

I have a washer dryer. It is not drying anymore. It is an Electrolux EWW12753

PCB repair. TACX Neo 2 power board SMD component replacement. Repair and then test trainer. Happy to bring trainer to your location.

I need to replace my garage door but would like to keep the motor. The brand is Merlin.

when you turn the straightener on it makes a sizzling noise and doesn't really heat up. Can this be fixed?

I have a Bosch series 8 washing machine (model WAW32640AU) Over the last 18 months it seems to be skipping spin cycle (especially when using cold water). At the end of the overall washing cycle the clothing is still soaking wet, however there is no water present in the machine. It seems to skip the spin cycle. I dont know whether this is water drainage problem or a spin cycle problem. I have opened the service flap in the bottom right corner of the machine and drained the water from the hose. The issue is still occurrng on average every second or third wash. I suspect the machine is blocked somewhere or needs some kind of clean out to fix the problem. Photos of the machine are attached. I am located in Hawthorn 3123.

Leaking pipes attached to pool solar system. Possibly manifold need replacing

Miffy remote just one button has stopped working. Need someone who can open it up and fix wiring I suppose?

The Samsung washing machine is not draining water and shows an SE error message.

We have a solar pool heater but when we turn it on, the rainwater tank overflows - pretty sure that it's a leaking roof pipe. Can it be fixed?

Dishwasher not working Need fixed asap

LG front loader washer dryer combo needing repair. When fills with water appears not latching properly and water leaking out the door.

Before 12:30pm. Dishwasher repair. Water is backed up at the base of the dishwasher and the filter is clear.

The program light of the smeg dishwasher is not on but the power light is able to turn on. When I push the dishwasher harder, the program light is on.(see attached photo ) My assumption is the program light button is loose and need to tighten

My house alarm is currently displaying FAULT and I do not know how to fix it. It is a BOSCH house alarm system.

Bosch in-built dishwasher is not draining properly and dishes are not cleaned properly even though the filter has been cleaned multiple times and a dishwasher cleaning solution has been put through an empty cycle. Sometimes the cycle just keeps running and never finishes. Internal “computer” been reset before but never solved the problem long term.

The fan on my fan force setting on my oven isn’t working. I would like the whole oven checked over and maintenanced.- brand is Platinum. Dishwasher needs maintenance. Doesn’t clean well except on heavy setting.- brand is Platinum

Suddenly, the blow fan does not work. (I can still hear the air-sucking noise from somewhere.) The heater is located in the ceiling. It may be 20 years old; I'm not sure of the manufacturer, but I can see the Honeywell thermo switch.

We have two outdoor roller shutters on the second floor, both controlled by a single wall switch. One shutter works fine, but the other doesn't, although the motor still makes noise when the switch is pressed. A technician previously raised a concern about both shutters being controlled by a single switch, which could have caused the motor failure, though other factors like water ingress, faulty components, improper installation, or an incorrect motor may also be to blame. We need someone to inspect and fix the issue. Please note this is on the second floor, and a standard ladder may not be tall enough.

LG front loader WD1200d Washing machine spin cycle is not working properly. Makes a funny sound when spinning. It's either bearings or the belt. Rotor seems to be ok and has no wear and tear.

We have a Bosch Serie 4 that is showing an E23 code. I have checked and cleaned the filter and impeller and seems to be clear so I suspect there is something wrong with the pump. Looking for someone to come over and fix. Would prefer if they had spare parts and could fix on the spot rather than have to order something in.