Find a reliable appliance technician in Blackburn South

Our pull down low row machine needs repair & service - ball bearings, wheels & cables require attention

I am getting an Error 1 message. I checked water supply and power supply, all OK

Need to reconnect washing machine water pipe. Maybe broken but not sure. Urgent. Needs to be done today.

Our Hills washing line wire snapped and it needs to be replaced. I have removed the old line wire but am unsure how to install the new wire. Washing line is similar to the image added. I'll buy the required washing line wire from bunnings prior to install.

4th photo: needs to replace 100mm vent with new 150mm vent (i already bought as first and second photos) 3rd photo: The canopy will be replaced with new rangehood by kitchen cabinet guys

Cook top spark ignition not working properly

Our laundry cabinets have shelves under the bench top but we want to put a dryer in there. Bench top is the right height as we have a washer at one end. Would require cutting out some shelves & the base & top support & provably cutting some new wood to support the cabinets

Help me install my four outdoor cameras, Single layer,.

Drill out holes in cupboard to connect washing machine and dryer

new circuit from switchboard (may be 32A) for induction cooktop model BOSCH PXX695HC1E. Kitchen is about 7m from switchboard. Single story house can easy access to manhole. refer to photo 2, new kitchen will be installed so electrical line need to be ready for the cooktop

Tesla wall connector installation. Wall connector will be provided, so only installation is required. Around 10 m between switchboard and the top all connector location.

The electric motor that opens and closes our front gate has stopped working. I think it's an electrical problem. Need an electrician to assess and fix.

Hi, I need a washing machine and dryer moved from Blackburn South to Croydon on Tuesday the 30th, be awesome if can set it up as well.

Gen2 charger. Over 5 years old. Red light flashing 6 times once plugged into car. Just normal green light until you plug car in. Car just says no voltage. Apparently means this: > Flashing red lights 6 times means there’s too much voltage or poor grid quality detected. If you’re using the level 2 charger, the power supply should be nominal 200-240 volts. Have an electrician remove the Wall Connector from the wire box and confirm that voltage readings are correct. Have confirmed there is 240V to the unit. Not sure what the rest means. Only apply if you think you can fix it. Otherwise better to just buy a new wall charger.

During recent work in my roof space a contractor noticed that the ducting for the a/c had disconnected in on position. I need someone to examine and repair this connection.

Need to build cabinet for stacking washer and dryer.

Need to install a range hood all the wiring and holes have been drilled just need to sling the 4screws on the panel

Need to install a camera above my garage door. I had removed the old one.

Wall mounting of Fisher Paykal dryer (model DE7060P2). Internal venting only. Wall mounting kit supplied. - Due date: Before Thursday, 25 January 2024

Qualified plumber needed to remove woodfired heater from slate floor, including flue, and repair tin roof where flue is currently protruding. - Due date: Flexible