Find experienced auto electricians in VIC

I need to get my electric scooters serviced and get my tyres fixed ad General service

We have a smoke alarm attached to the roof which is 5-6 metres high. The battery has gone in the smoke alarm and it keeps beeping. We just need someone with a high ladder to come over and change the battery. It should only take a few minutes to change the battery. It’s just getting a ladder that is high enough to reach the smoke alarm, and open it to find out which battery we need, and then to put a new battery in it. The longest part will be setting up the ladder. all in all, it shouldn’t take longe to do. Maybe 30 mins or 40 minutes maximum.

Hi I have a Toyota Prado and I have had pioneer ts d65 speakers in the front of my car and a pioneer gm d8704 amplifier. I previously used another airtasker person for the install and I am a little disappointed because after the install I had an issue when the music was turned up the sound was clipping. The installer told me that it would be because we didn’t change the factory speaker wire. I want to speakers in the back now and would like a price please.

Need to install car charger at my home

Cbr954 been stripped of old fairings due to accident and have brand new headlight fairings to be put back on, everything ready to go, may also need help ordering a few bits and peace’s to fully tie it over and complete repair but have 98% of parts needed for a solid days work.

key ignition popped off on a ford ba and need to be replaced

I have purchased a brand new battery for the car as the old one is completely dead, however I don’t have the tools to remove the old one & install the new one myself 🥲 Need the car for work tomorrow… 2010 Holden Captiva 3.2L V6

i already bought the parts . just need a hand to replace it

Old camera lens is cooked. Have purchased a new camera but am struggling to wire in the new one to existing wires fed to back of Ute.

Front and rear dash cam installation for my car (Toyota Corolla) The brand is 70mai After 4pm

Need someone to replace the broken headlight on right hand drivers side. Model is Mazda 3 2016 maxx. I have the new headlight. No damage to panel but might need very minor placement back to original location - almost not visible.

I currently have a dash cam wiring front, read, battery protection. The new dash cam has USB-C cabling, old was is micro USB. I can't use convert or adaptors. Hence I need to rewire. Car is Mitsubishi Outlander I am in Carrum Downs 7am to 2pm Endeavour Hills after that.

GPS(moovetrax). Auto electrician half installed this. Still needs remote unlock and lock function and fuel monitoring completed.

I have purchased a UNIDEN Uniden DASHVIEW60R Stealth 2K Rear Dash Camera… I need this installed either today or tomorrow latest … the hardwire consists of three cables - one yellow that connects to battery (+), red cable to car ACC, and black cable to ground… I have all the cords etc in the kit

Need front and rear dash cam installed in my 2018 Mazda 3 Dash cam is GKU, no hardwire required

Can someone with experience please supply and install an android CarPlay and reverse camera for my vehicle please? Vehicle: 2010/11 Mitsubishi Triton, GLX-R MN (MY11). Images attached. Thank you 🙏

Purchased two dash cams (photo attached) Wanting to get it HARDWIRED to the fuse box both front and rear. Not cigarette plug as I want it to run off the battery. Cars: 1) Toyota CHR 2019 2) Honda Crv 2004 Both cars on the same day and are on the same address. Ideally weekdays before 6pm or weekends. Please include quote for one CAR and if satisfied it then we can do the other car same day.

Need someone to remove a starter motor bolt E14 on my bmw 1 series.Bolt is stripped hence why l couldn’t remove it.

Looking for a skilled professional to install and hardwire a Viofo A229Plus 2CH Dash Cam in my MG EV. The installation should be neat and flawless, with no visible or hanging wires. The task requires someone with prior experience in hardwiring dash cams, specifically in electric vehicles (EVs), as the process might involve specific considerations for wiring and power management in EVs. Requirements: Experience with hardwiring dash cams, particularly in electric vehicles. Expertise in routing wires neatly, avoiding visible or hanging wires. Familiarity with Viofo A229Plus model and how to integrate it with an EV's electrical system. Provide a clean and professional finish. Test the camera to ensure it’s working properly after installation. If you have experience with hardwiring dash cams in electric vehicles and can ensure a professional, tidy result, please get in touch! Looking forward to hearing from you.