Find experienced awning repair handymen in Brisbane

Paint front of one-story post-war cottage, as well as awnings under guttering and guttering around whole house - the back and side awnings will require ladder/scaffolding as high off the ground

I have a somfy outdoor blind that is currently unresponsive. The remote is blinking red, and from what I read is that it requires the motor to be reset. Anyone who has experience with somfy blind?

We have a restaurant in Uptown Brisbane (formally known as Myer Centre). We have a large deck that has retractable awnings all along the balcony. One of these was removed as it became loose and needs to be re-installed. Please contact me for more details

Outside awnings need repairs, inside roller blinds need repairs and security sliding doors need servicing

Motor does not have enough power to lift the awning in our unit. It needs to be replaced. Task involves supply and install

Need help installing a retractable awning to the roof of house. Ideally someone who has experience installing brackets or similar onto roofs. I have already purchased the awning and have found appropriate brackets to complete the job, but I need an experienced builder or handyman to install the bracket onto to the roof. We can help lifting awning onto the bracket once they are in place. I've attached photos of similar installs

Hi there, we have ripped our canvas awning in one section, would like to receive assistance with getting this fixed.

Pick up and install a retractable screen on my balcony. Awning will need to be collected from Newstead Bunnings. May need bigger anchors than included with the awning for increased strength. Will have to drill into very hard concrete slab to anchor awning.

To replace rusted awnings from house and re-sheet. Place meeting to possum Proof home in 2no. Locations

Install a 3 metre wide window awning above a sliding door and a small awning above a solar inverter.

Looking for an aluminium awning fitting person for front deck. Please note custom brackets will be required. Please see attached pictures. The front deck Down pipe has to be refitted.

We need to install HDPE sheets to the awning to try and make it more watertight. We would like to use these sheets, if possible (2000x1000, black), but open to suggestions if you don’t think it is suitable. https://plasticwarehouse.com.au/product/hdpe-sheet-pe-100-simona-engineering-plastics-cut-to-size/ We will purchase the sheets but will need you to collect them from the factory in Eagle Farm. Works to be done: 1. Collect HDPE sheets from Eagle Farm 2. Install HDPE sheets on top of the steel/ timber awning 3. Screw into the timber to secure 4. Cut out ridges to make the sheets flush to external wall 5. Seal/ silicone all joins to make watertight Notes: - Please includes all fees, materials (except for the sheets) and so forth in your quote - Awning is approx. 3m above ground - Located in Spring Hill - Awning is approx. 10m x 2m - Please ensure you are experienced & insured Thank you

There is a rotten component to my window awning that I need replaced so that it can be painted. The painting is due to begin on the 31/7. Hoping you can replace the affected area of wood rot. Painting not necessary, will need to provide materials. Security camera to be removed and does not need to be replaced. Height is 3.6m.

Repair of one arm mechanism on motorised outdoor awning that rolls shade up/down. Happy to facilitate inspection/quote to properly understand what needs to be down.

I need 3 corrugated roof panels on my carport and a single window awning removed to allow for the installation of an air-conditioner. The carport roof panels also need to be replaced after the air-conditioner has been installed. Only registered builders please.

Fit roof racks and awning to Holden captiva

One side of a bracket to an outdoor awning is broken. I need a new bracket installed that can hold the awning. I dont have a replacement bracket. doesnt need to look the same as other one.

Middle pane of a triple-pane top-hung awning window is stuck open approx 30cm from base (winder handle has been detached). Frame along top appears to flex/bend if attempting to force it closed. Need help fixing - may need hinge or panel adjustments, re-hanging or other solution. Total window dimensions is 2400W x 1400H. Top of window is difficult to reach - may need ladder if work needs to be done along top of frame. Pictures show window from inside, and how far middle panel is stuck out from outside.

As above. There is a brick wall on one end and and a slatted barrier on the other. The railing is waist high. I am on 2nd floor. Wall surface above and around door is standard red brick. I have approval to do this work.

require contractor to install outdoor and indoor blind, ongoing work must have experience - Due date: Flexible