Find a professional blueboard contractor in Melbourne

Remove and replace blue board that has gone rotten. You will need to come on site, measure and collect the material. Only the bottom half needs to be fixed

I need five 1200x2400 sheet of blueboard fixed to an existing timber wall on the first street of a building. I also need about 20m of flashing fitted over the blueboard

We had an old electricity meter removed and now have a gap in our wall. We need a piece of Blue Board cut and fixed and then the section filled in. We’re getting the whole wall re-rendered at some point so don’t worry about perfectly matching the surrounding render. Just needs to look roughly right and match the surface level around it.

- Corners tapped (or whatever is needed, see pictures) - Joints tapped - Rendering corners and joints

Hi, after someone with rendering experience to patch up a few bits of our garden wall (blueboard), where flower beds used to sit. Colour is surfmist, need it done today. Located in Richmond. Areas to be patched up are below in m: 2x.07 3x0.7 2.7x.6 x2

I need the front of my house Blue board to be replaced as the front appears to have rotten away. and the rendering to be done. - Due date: Flexible

I need blueboard purchased from bunnings to be screwed into the fence and then painted. I then need two planter pot rails to be screwed into the blueboard. - Due date: Flexible

Install blueboard infill and reinforce double glazed windows x 2 and install architraves - Due date: Needs to be done on Saturday, 11 March 2023

We have a newly installed blue board fence measuring in total approximately 22 metres by 2.2 m high. It is in the backyard of a SF terrace house with rear lane access. Please advise on the best product to use, either render or textured paint and quote to complete same. - Due date: Flexible

This will fell down with the wind. Need someone to break it apart, remove and take to the tip. Aberfeldie job. Size of wall approx 2.7h x 3m w

Carpenter needed! We had our house restumped. The lower weatherboard planks had to be removed, as well as some sections in the front corner of the house which is rendered. Looking for a carpenter to put up weatherboard along the sides of the house, and blueboard with vents for the front/corner of the house which is to be rendered at a later date. Area is approx 26m in total length X 40cm in height. Would appreciate in-person quote for accurate understanding of the job. Materials not supplied. Painting not required.

Reboard an outdoor partition wall with plywood as base then blueboard. Approx 2170mm(h), 1330mm(w). With side section approx 2170mm (h) 230mm(w) Materials will need to be supplied by tradesperson - Due date: Before Saturday, 23 July 2022

Looking to extend or rebuild a small wall. See pics for measurements Open to either Blueboard and framing with some carpentry or look at bricking it up. I’m not fussed. Don’t need to render. Easy access on the street, looking to get sorted this week.

I want to extend our wall to make a 1.7m high x 2.8m length wall between properties. See pics! With a timber frame on top of the current wall (140 width). Then glue Blueboard to Lower wall and screw into frame. Finished to be with edging / corners so we can render. Frame to be dynabolted into the lower brick wall for security. Confirming that both sides need the Blueboard so the neighbours have a good finish to. Located in St Kilda East parking available.

Hi there, I have a hole in an external rendered wall made from blue board that needs to be patched up well. It’s no more than 50m x 50m. No painting / rendering required unless you’d really like to! Located in Prahran, very flexible availability. Thanks, Dave