Find a local brick fencing contractor in Melbourne

The screw attaching my front gate to the brick post has sheared off. Half of the existing screw is stuck in the brick. I need someone who can extract the existing screw from the brick and reattach the gate to the brick with a new screw.

We have a 6ft high brick fence that needs some minor repair to mortar , scraping off old paint and repainting.

Driveway to be opened by an additional 1m (min) as per attached plans. Works include: - dismantle existing brick work to provide additional opening of 1m +. - replace bricks in original pattern. - re render with stucco. -make good surrounding footpath. Will likely need a concrete base for stability of bricks. Painting not required. Hedge will be removed prior to works commencing.

Brick fence approx 4.2 m long x 1.8m high. Pull down bricks and piers and dispose of all debris. Gate can be left alone. Bricks to the right of gate have to go as the fence is falling over. Only demolish to street level. Footings can remain. There is a clearway in front of the house until 9:30am weekdays. Parking ok after then

Existing brick fence repair and modification job

12 meters brick fence with 150 cm height like this photo

Demolish brick fence. Remove bricks from site

Quotation is a Must since it is a shared fence. While paling fence needs to be replaced. End of the paling there is an existing brick fence which is missing some bricks and that needs to be fixed. Bricks are available.

Old brick fencing is tilted, want to replace it with colourbond fencing please. We share our fencing with the housing commission next door, need the housing authority to agrees with the Quote, they will be arranging their own Quote too.

The branches of the tree are overhanging into neighbours yard. I will need the trees cut from my side of the brick fence. No need to remove wood/branches. I can provide more details of job or photos if needed.

Need a quote for removal of the whole fence and either rebuilding 1m high picket or bricket fence

Two Coates semi gloss white

Need bricklayer install for a letterbox integrated into brick fence Been told need 20 or so bricks also need front and backsame height and width as the bigger pillar See picture smaller pillar is the one I want to make a letter box out of

4m brick fence knocked down, 2m old brick barbecue knocked down, 1m x 4.5m of concrete pulled up and removed

I would like to construct a new brick front fence. 6m long 2m hight. Demolish existing 600mm brick fence. With cast in steed gate detail. Similar to photo shown.

I have a brick fence that is 600cm x 145cm tall x 22 cm deep. That I need to be demolished. It is 35cm deep at certain points along the fence and it is 155cm tall at its highest points. It does not require a permit to remove but does require hoarding and hoarding permit. The bricks and debris will also need to be removed.

Hi there, I’m looking for someone to demolish our front fence which is rendered brick. We’re looking for this to be done within the next couple of weeks ideally. The fence is approx 600mm high, with the long section being approx 5900mm long and the shorter perpendicular section @1500mm long excluding the gate. We have obtained a permit from the Council to do this. Please see photos attached. Thanks in advance, Claire Note: thanks to all who have posted a question or offer. I forgot to mention that I would also like the footing demolished - to at least 1 foot below ground level (not actually sure how deep it is). Thanks again, Claire

The brick work is for a rear back gate and is accessible via a lane. It needs to be repainted inside and the exterior. Paint will be supplied. Two coats is preferable to ensure an even finish. Images below show the scale of the job. Air Tankers would need to bring drop sheets, ladder, brushes and turps.

There is a brick front fence that needs repair. Job is to view and provide quote with scope of what needs to be done. - Due date: Flexible

I have two hard plastic lattices I need attached to a concrete fence and colorbond fence - Due date: Flexible