Find a local Tasker to restore your car in South West Perth

Car restoration projects start with careful research on the car’s original condition. With Airtasker, you can work hand-in-hand with an automobile expert from the comfort of your home, workplace, or garage. You can give specific instructions and provide the parts and tools that you want your service provider to use, or ask them for recommendations. You can choose to have only specific parts like the paint or leather car seats restored or go for all-out classic car restoration.

Depending on the appearance you want to achieve and your vehicle’s needs, your car restorer will be handling the following tasks:
 
Preparation for car restoration
Clear a space for the whole process. Keep in mind that your vehicle and car restorer will be in that space for a long time, so make sure that the work area is not obstructed and that it won’t block any passageways in your home or garage.
Take lots of pictures and share your research or desired look beforehand. Make sure that you and your tasker are aligned in terms of how you want your car to look.
 
Disassembly
Your tasker will start removing your car’s gas tank, battery, chrome and stainless steel pieces, glass parts, and seats. After this, your car’s headliner, door trim, interior trim, and carpet will be removed. Your car’s dashboard instruments will have their wire positions marked before removal. Finally, your tasker will remove the boot and bonnet lids, the doors, engine, transmission, body, and suspensions.

Do note that the whole disassembly process will take around 40 hours alone.
 
The main event: Car restoration
Your car restoration expert will then clean, repaint, re-plate, and re-chrome your car’s parts and accessories. They will also handle repair work that needs to be done. Depending on the need, they can even replace any parts or re-upholster the seats. They can strip, clean, and repaint your car’s frame, weld in new metal, and replace instruments like the car’s radio and heater box.
 
After car restoration: Reassembly
Once you are satisfied with the restoration of all the components, your tasker will rebuild your vehicle. The usual process is to install the wiring harness, followed by the dashboard instruments. The interior trim will be replaced, followed by the front and rear glass. Then, the doors will be rehung, the seats reinstalled, and the boot area fitted out. Then, the bumpers and exterior trim will be replaced.
 
Before putting the lid on the bonnet, your car restorer will check if the vehicle is in good working condition. At this point, you’ll want to check on the project yourself, to be sure that everything’s hunky-dory before you hit the road.