Find a professional local car service in Mornington Peninsula

Would need to be done in a workshop and prefer someone that has done this conversion before

Need the wiring to be hooked up to high beams with cut off switch inside the car to turn light bar on and off if I don’t need to use it with my high beams

I’m picking up my car on the 26th of this month, I’m in need of a mechanic that is a decent price to have a look over my car and someone who could also possibly supply ford falcon xr6 wheels that would pass a roadworthy certificate don’t want to drive to far out of the Frankston area but can if need be I am open to getting quotes too

Bonnet respray for Toyota Rav 4 2004, no dents or damage, bonnet has been removed from vehicle.

I need a wireless reversing camera installed in my Ford Eco Sport please 😊

Rear brake pads replaced. Pads provided also dashboard cleared from work on the front right.

to change bmw x5 2008 front h7 bulbs.

I have a 2020 honda CIvic VTI. VIN MRHFK4860LT070316. I would like someone to carry out following task: Replace: Transmission fluid Brake fluid Fuel filter Pollen filter Air filter I will provide parts as well as oil for transmission and brake. Please let me know if you have any questions.

I'm planning to purchase a car from a dealer in Seaford VIC. Would like to get a pre-purchase inspection done for it before finalising the deal. Car is a 2008 model

Hey all, • I am looking for an Automotive mechanic to complete out a full body service on my 2007 Vz Holden Crewman. • The engine light is currently on telling me to "check powertrain". • Vehicle is located in Frankston 3199. Please place your offers / suggestions as any help is much appreciated. ☺️

Wanting to get a reverse camera and apple car play installed into Hyundai Tuscan 2007 Give me a message and a price :)

I really need someone with mechanical knowledge of how to change the gasket on the exhaust manifold in my 2007 Mazda cx7 so I can get a Roady done and registered. I roughly know how to but don't have the tools and need help as I'm a woman so may need help with difficult parts

I need a wheel bearing replaced on a Renault master left front. Press in. Bearing supplied.

Installation of REDTIGER F7NT DashCam - Front and Rear - in a Mazda 3 2015 model ensuring wiring is hidden as much as possible and of course suitable positioning of the camera. Looking for a professional finish/job. Appreciate it.

Would like a quote please.

2014 Nissan Altima front speaker replacement. Need interior panel removed, speaker removed, new speaker wired in. Would take about an hour for an experienced person. Replacement speaker would cost approx $40-$60

I don't have the tool to pressure test my Ford ranger cooling system started overheating changed water pump and radiator ran fine for a month then overheated again I've changed thermostat pump radiator and put new coolant bleed system after an hour the car was just getting to run temp left for another 30 mins still cold but slightly warmer on left side of radiator coolant to touch in funnel cold put cap on corect level in overflow bottle let it sit for an hour then drove for ten mins looked lid blew off bottle and air in radiator but still stone cold ??? I need a hand to fix this problem asap

90,000 klm major service on a mitzabishi ZL outlander SL

I have replaced a damaged headlight and need to pull dent out of bonnet before replacing bumper. Most hard work done just having trouble getting bumper to go back on. Should only take half hour max. Wanting it done today. Bonnet will be replaced later. Just need car back on Road for now.

I need someone to fit 2 new camshift sensors and one crankshaft sensor to my Nissan 350 Z not a difficult job just a bit fiddly. Willing to pay $100 cash.