Find experienced local carpenters in Canning Vale

I want doors for my theatre room. Looking for carpenters numbers who are able and willing and not too expensive. Got one quote but not too sure how to gauge whether it's a ridiculous one or not. I will order the door I want so quote without the door cost, just framing and labour and whatever else needed.

Remove and install laundry cabinet

I'm enquiring on behalf of my elderly mother in Perth. We'd like to have your quote on the installation of a new dishwasher into a kitchen island. This will require carpentry of a dishwasher recess, electrics, and plumbing. I understand that it can be hard to quote without inspecting the area so we're happy to help facilitate that.

Need to get a kitchen bench top replaced. We will provide the bench top. In Canning Vale

We are a builder and need someone suitably skilled to install aluminum skirting in an office fit out we are doing. We will supply the skirting and the glue required to complete the job. You must have White Card safety certification. You must have good experience with compound / miter saw. The black skirting comes in 1.6mm x 100mm x 6m lengths and it will need to be scored, bent and accurately cut to size, then glued into place on to newly constructed light weight walls. Prior to commencing we would like to show and talk the person through the job. A suitably skilled person should be able to complete this in 1, full working day.

This job will take about 6 or 7 hours starting at 0830 at our site in Canning Vale. I will be in attendance with 1 other person also assisting. I'm seeking a general hand to help me undo office partition and take down 1 flight of stairs and put in bin. Also need to cut up existing carpet into 1800 wide rolls and store next to bin for carpet contractor to take away. Other similar type of tasks for internal office demo. General tidy up upon completion.

Cut square pavers around the shed

Like the one pictured but different measurements

Require removal of current bench top film and replaced with a new vinyl covering or open to suggestions to cover/seal it.

Im interested in purchasing a shed from easy shed however i dont know how to put it together just wondering if youre able to help me and how much it may cost

Need to sand fill and stain one table and two benches same colour as you see ,material not included

I’m looking for someone that’s able to install a 4 m wide by 5 m deep shed in our backyard

I have 3 internal doors that needs to be trim shorter as we have thick carpet installed.

I have attached photos of work need to be done.

I am after a quote for supply and install of a walk in robe for my new house. I have the plan/design that I like.

measure and check old door for size supply new XS26 door from bunnings (Hume 2040 x 820 x 40mm Entrance Door SPM Lincoln XL2) deliver and install with japan black paint install supplied door hardware of lockwood silver entrance set

Looking for a Professional Carpenter that can build me a Staircase Shelf. Looking for someone to quote me possibly 2-3 shelves

Assemble a flat packed small steel garden shed and fix it to the house outer wall. Similar to an existing one in the picture.

I need a new stone Benchtop please. I need it supplied and installed. There is 2 cutouts, the sink is top mounted. The pieces are approximately 1545 x 620mm 2725 x 620mm 1860 x 1000mm I’m not fussy with colour. So if there is a particular one that’s cheaper than the others, I’ll take that. Old Benchtop was laminate and will be removed prior to installation. Job is in canning vale. And the job is ready to start.

Needs a 12 cm hole drill into existing 3.5 cm thick particle board bench top. Will prefer someone who has portable drill guide to ensure professional finish. picture marked with red circle to give you the idea.