Find experienced local carpenters in Chiswick

Install 5 shelves in linen closet. Shelves are 1200 wide by 600 deep. May need to be cut 1-2cm to fit.

Pick up 5 shelves from Bunnings Ashfield (already paid for). Cut to size and install with L shape brackets in linen closet. Ute or van required and tools. Wall behind is concrete for drilling

We have just purchased an apartment and would like to get an estimate on renovating the kitchen. We would like to (depending on cost): - Replace bench top - Replace splashback - Replace cabinets and drawers - Replace sink - Replace oven - Replace cook top - Replace exhaust If we can please add the below on as separate estimates. Depending on the complexity, cost and strata approval: - Lower the bench top so that everything is the same height - Move the bench with the sink over towards the living area so there is more space in the kitchen Here is the online listing to the apartment that has photos of the kitchen + a floor plan. https://www.domain.com.au/57-1-janoa-place-chiswick-nsw-2046-2018677431 Please let me know if you need any more details

I want to cut my cupboard to fit my dishwasher Need to cut 600 wide and only leave the benchtop on It’s old kitchen so it doesn’t have to look super pretty As long I fit in my dishwasher

I have shaving cabinet Has been installed wrong The shelf meant to sit on bottom I want to reinstall it again

We need a Carpenter to go into a cupboard and cut away some of the cabinet to provide access to the plumbing behind it.

Cooktop and sink will already have been removed so a couple of cut out sections of old benchtop will remain. I will detach benchtop from edge (this has proved t be easy with one piece already. Your job will be to wiggle/lift out the pieces of benchtop which I will then put into a trolley and move my garage. I am happy to send photos. - Due date: Needs to be done on Wednesday, 17 January 2024

Cabinet storage in a hallway for 1 bedroom. 1 cabinet needs to be floor to ceiling storage and we’d need shoe storage with seating preferably. No sketching and design prints need help with this. Will pay for quote/measure/design Approximately 3-4 metres. Need storage as have a baby due soon. - Due date: Before Saturday, 25 November 2023

Build matador pizza oven - Due date: Needs to be done on Sunday, 6 August 2023

I have a 2800mm x 1200mm x 12mm echo panel (pinboard type material) that needs to be cut to size using a circular saw or band saw or by hand with sharp carpet knife. This can be affixed direct to wall using commercial adhesive. This is to be installed in the home office and I can share the instructions. I also have some picture rails to be hung in the same space. - Due date: Flexible

Timber floor in kitchen raised in 2 areas due to water leak which is now fixed. Timber panels need to be taken out and either reinstated or replaced - Due date: Flexible

We removed a microwave and want 2 drawers to fill the space left which will match the existing cabinetry. We also need a new matching fitted panel to 'dress' the front of our dishwasher. - Due date: Before Saturday, 16 July 2022

I have two existing drawer units and i have upgraded the doors and other detailing but i need someone to assemble and install the Blum Soft Close LEGRABOXES into them. I have the jig for the new runner holes from Boards and Benchtops, all parts required and all drawer fronts in total everyhting you need to assemble and install 6 Legraboxes. Trade must have documented kitchen installer references or a Carpenters Licence minimum. - Due date: Flexible

Need a composite deck installed in my outdoor courtyard. Nothing needs to be removed, happy for it to be placed directly over existing surface. Measurements are 6.5 x 5.5m.

The piece of board needs to be cut so we can get her out. Its the botton of cupboard where fridge goes. A small space above that like a vent.

We want a handmade trundle bed built with quality material and good support given will be the main bed used by my kids. Color : timber Material : wood We have an existing single bed and we need a custom made one to go under as a trundle. High is 22cm and lenght is 198cm

3 meter shed from Bunnings needs to be put together