Find experienced local carpenters in City

build a wooden cube plinth around 18 cm x 18 cm x 22

I am enquiring a quotation for removal of slime stain up on the ceiling with 4 meters height and approximately 2440m2.

I want to make this wood log tv floating shelf 90-100 cm long

Sanding a wooden (ash) guitar body, removing current nitrocellulose finish - Due date: Flexible

This job is for initial consult only. Looking for a carpenter or joiner to replace an existing commercial kitchen swinging door. The existing door can be salvaged but because it's heavy, it'll pulling at the hinges and starting to rip the frame off the wall, thus new framing is required. I'm open to quotes for either of the following options: Option A) Keep existing door and replace the frame + add new side hinges and an above 'door closer' to support some of the weight Option B) Replace door with a light weight door and replace framing Appx measurements of the existing door are: Height: 2320mm Width: 870mm Depth: 45mm - Due date: Flexible

Need someone to stop by and cut a piece of wood to a set length of 40.5cm by 73.9cm Note: I've got the wood of course and it is 40.5cm wide so this is a single line cut.

Need someone to drop by and cut two bits of wood into the dimensions in the photos Main plank is 1200 x 300 Cut into 1200x140 600x160 160x150 (4 of) Second plank cut into thirds

Brand: Chanel Problem Description: 1. glass at consultation bar at Skincare table is chipped, need to be replaced 2. Plinth at the PlayStation/Lightbox is broken, and wood exposed 3. At Playstation area, the left hand side has a broken frame, the right hand side has a broken hinge/bottom part on right hand bottom corner 4. Cupboard doesn't close properly on the small fragrance bar area 5. Broken frame on both sides of male fragrance bar; Broken frame on one side of female fragrance bar 6. Bottom draw on skincare bar doesn’t close properly, this whole fixture moves - needs looking at, currently sitting crooked on the floor - Due date: Before Friday, 9 December 2022

I'm after a carpenter who can make a kitchen-door with the below dimensions: 2320mm (H) x 870mm (W) x 45mm (D). It will be replacing an existing door as per the images attached. I'm after a light-weight wood material. - Due date: Flexible

Fix below item 1. One Woden drawer (pic 1+2) 2. One Sliding door of storage cabinet (pic 3,4&7) 3. Magnet for steel cabinet door (pic 5&6) - Due date: Flexible

Looking for a carpenter/cabinet maker joiner to Adjust and make level kitchen overhead cabinets carcass and doors as shown in photos You will need to supply and use dropsheets and foam protection over existing benchtop and Cooktop

Leakages from a radiator have left an oily film and stain on the floorboard.