Find experienced local carpenters in Coburg

Build a timber base for an easy shed. The dimensions of the base are in the photos along with an example of what I’m after. The fee is for completion of the work and your time and I’ll reimburse you if you supply the materials.

Sand and stain Merbau decking. Size 6m x approx 3m. Thanks

We would like to build a small corner bench seat in our dining room. Would be 2000 x 400 mm approx in an L SHAPE. We would supply all materials Just need to supply tools, design and labor

Assemble a skillion roof easy shed (1.5x3x2.1). Fix the easy shed to a rebated concrete slab.

Hi, I need a simple set of shelves built on the right hand side of my hallway cupboard (see photo). Basically identical to what's on the left with a gap left in the middle for our ironing board. Flexible on time, and price is just a place holder - I'm not sure what this should cost. Measurements are 37cm deep, 200cm high and 60cm wide.

Hi there, I'm after someone to adjust some kitchen cabinets, as the hinges have come loose, causing the cabinets to drop

I need two side gates built and installed i have 2 colourbond sheets that can be used with a new frame (to be built) - they will need to be cutup if the sheets cant be used, then i will buy two gates from market will also need to install locks width of the side path is 1.2M

Looking for someone to sand/clean and stain decks. Front deck was new in June and is approx 2.2x3.7m including a front step. Back deck is approx 4x6m including step. Also have one small step out the back to be done as well. We can provide stain if needed - type/amount required to be discussed.

Create a built in wardrobe in the style shown in the photos. Dimensions are 2mx0.8mx3m

Wanting 3 x Floating Shelves installed in my study nook. They are the floating shelves from Kmart, each are 110cm in length for a 143cm area of width. Honestly just needing someone with a drill to make the frame secure. Tried to do this myself and failed miserably.

Install model DTG -3030, 3 x 3 x 2.4 metre easy shed. Install and affix on existing concrete slab. No instruction manual available,

Cross beam holding up wooden garden step has rotted and needs replacing

We changed from carpet to engineered oak floor. Urgently need two small bits of skirting installed before the caulker comes on Thursday

I have a new Westinghouse dishwasher that does not fit easily into current dishwasher underbench cavity (image 1). Whilst the dishwasher would fit, the cavity is slightly out of alignment and is a squeeze. I suspect upright cabinet support to right may need to be removed. Not sure if upright screwed or glued. New holes for dishwasher inlet & drainage pipes would then need to be drilled to bottom right of dishwasher cavity. Pipes would go under kicker to the right and up through another hole that would need to drilled in floor of rear right under sink (image 2). I think this needs a qualified cabinet maker/joiner. Whilst you are here I would like to get quote to look at planing bottom of back of linen cupboard door as it is catching on the bottom (see images 4+5).

5.5M LENGTH BY 2.56M HIGH GARAGE PARTITION WALL TO DIVIDE TWO GARAGES. MADE OUT OF PLY WOOD, WOODEN FRAME, ONLY SHEETED ON ONE SIDE. WANTING A PROFESSIONAL CARPENTER FOR THE JOB

Assembly of a flat pack Shed. Shed measures H 1.8m x D 1.07m x L 2.1m. Rivet tool and rivets provided. Instruction sheet provided. Purchased from this site: https://www.greenlife.com.au/products/yardstore-f63-d-garden-shed-2-1m-x-1-07m-x-1-8m

Come out to quote for and then frame out and install cavity door. Plaster over cavity frame.

- sand and re-stain small outdoor wooden shed. - front and x1 side only

Need this shed assembled https://abscosheds.com.au/garden-sheds/pool-pump/bin-cover-1-52mw-x-0-78md-x-1-15mh/

I want to add an extra shelf in my pantry on two shelves. Haven’t measured yet seeking quotes and advice through here.