Find experienced local carpenters in Croydon Hills

I need a carpenter/handyman to build new doors to replace those currently on my barbecue.

I am seeking a quote for the cost of labour (not materials) for replacing a 4.8m length of treated pine handrail on my front veranda steps (140mm width x 45mm depth). The current handrail has rotted and needs to be removed and sawn into several shorter lengths for ease of disposal. The new length of handrail needs to be affixed to the four upright posts with 8 hexagonal bolts/screws. The new handrail then needs two coats of wood stain. I will purchase materials.

Door Framing - Casing built

I’m looking for a professional job to lightly sand or clean current deck then tape up edges and stain my merbau deck. I will provide the stain and tape.

Plastering a hole left from the removal of a built in wardrobe . Includes fixing the cornice and patching a small hole from the removal.

Dismantle existing shed and remove from site - leave interior power points in place Assemble new flat pack shed 3m x 3m with one sliding door on existing 3m x 3m concrete base Re-attach power points for swimming pool filter and pump to back of new shed - Due date: Flexible

Hello. I am after a cabinet maker to supply replace 3 polytec kitchen end panels The current panels in the photos are basic flat melamine but i would like them to be replaced with polytec end panels that match the profile of the current polytec door and drawer fronts. The measurements of the panels are as follows approximately: First Panel (on breakfast bar) - Height is 85cm and width is 85cm Second panel (near stove top) - Height is 85cm and width is 57cm Third panel (top cabinetry) - Height is 69cm and width is 33cm. The "design" is Ballarat EM2 Thumb Mould and the colour is Classic White. I have attached a link to the polytec product. https://www.polytec.com.au/product-custom/ballarat/ - Due date: Flexible

QUOTE NEEDED. I want a deck built (using composite material) over my concrete front porch and steps, and I want a privacy screen (using VJ panelling) installed to block off my carport. See pics for more info. - Due date: Flexible

The drawers are part of a Depression era cabinet. They each measure: front and rear - 54cm long x 17cm high sides- 38cm long x 17cm high The material runs along the top edges, then 3cm from the top inside of each drawer. The colour and design need to be tartan, similar to the photos. I can deliver and collect the 3 drawers from your premises if preferred, although perhaps the task might be done here in our home? You’d purchase the fabric or we can do so, if preferred. - Due date: Flexible

New built in double oven installed replacing existing oven. New oven not as tall as existing oven. Would like a shelf or something installed to raise oven right up and maybe create a shelf space below - Due date: Before Friday, 14 April 2023

Front decking is beginning to fade. It needs re-doing. I need you to supply the stain or oil and complete the labour - Due date: Flexible

We have taken all the wood off a pianola and left with the backing plate. I think it's cast iron and still has the (I think) bronze strings attached. I would like it removed. Has 3 steps to go up. I guessing it would weigh 150-200 kg. - Due date: Flexible

We have some regrets about this monkey bar set, but would like to help it last as long as it can. * Stain wooden poles, (you may need to use a filler where minor splits have occurred first, or even duct tape if that'll work? Haha), and install monkey bars in grass area, without using concrete. Can used crushed rock or anything we can remove later. * Stain supplied. * When it was previously installed it was a bit wobbly, so I appreciate your skills in making it as strong as possible please. * Date/time can be discussed. Local to Croydon Hills area please in case two trips is easier / gives time for stain to dry? Open to discuss. Thank you 😊

Need this shed assembled it is going on concrete so would like it secured to the concrete flexible on days See picture for exact Shed from bunnings - Due date: Flexible

Need an overhead two door kitchen cupboard removed to allow a new fridge entry.

We need someone who is comfortable to pressure clean, sand & stain decking