Find experienced local carpenters in Fremantle

Modifications to existing 1970's kitchen cabinetry as follows: - Remove bench top including cook top & sink - Modify cabinetry below sink to suit dishwasher installation (600mm wide, under-bench) - Modify cabinetry to suit 900mm wide oven below cook top (currently 600mm wide and located left of the cooktop). - Install runners to 4x drawers to ensure they run smoothly - Remove section of existing cabinetry in the corner (approx. 1.5m + 1m) and replace with full-height pantry cup/a and fridge recess. - New stone benchtop Cabinetry is in good condition hence we'd like to keep the base cabinets wherever possible. The door & drawer fronts could be relaminated (Option 1) or replaced (Option 2). Please allow for both. No overhead cupboards. Electric oven and cook top removed by others. Kitchen approx. 3.6x3m in size and has timber floors. Skip bin available for demo materials. Scope to be refined at site inspection (early January 2025). Must be available to complete works by mid-late March 2025.

Carpentry job. There is a small approx 5/6cm gap between the floor boards and the wall, extending approximately 1.5 metres behind our fridge which we have noticed when we pulled out the fridge and would like filled with a permanent wooden board so that there is no gap. It does not have to be aesthetically pleasing as it is not a noticeable area in the kitchen just something we would like to have filled.

We have a 38ft boat at Fremantle Sailing Club and are looking for a qualified flooring specialist or shipwright to sand and reseal the flooring, in addition to refinishing some of the other parts of the wooden interior. Quotes welcome.

Im currently renovating and looking for a carpenter to help me finish the reno. We have a deck to build, patching in some.jarrah floorboards, 3 doors to be installed, skirts and architraves. And a list that's keeps growing.

Needing a third set of hands to assist two carpenters with the replacement of some existing timber cladding with new cement sheet weatherboard. Starting 7am tomorrow (Thurs) till approx 3pm and same again Friday. Job may extend into Monday and Tuesday if also available and weather permits. Attached budget price is for one day, can adjust for additional days / hours as needed. Basic hand tools would be helpful but absolutely necessary. All materials supplied and on site.

We would like these under stair shelves to be hidden but still accessible and usable.

I have a small Burmese cat, and need to install a total of three cat doors into the beautiful old pine doors in my fremantle home. I am looking for something willing to do this with attention to detail and care for the original doors that are currently in situ. I am yet to purchase the cat doors themselves, and can do in consultation with whoever takes it on :) May require replacing one panel at bottom of door. Mouldings can be removed. Look forward to hearing thoughts and interest! Open to ideas too — looking for something in keeping with the character and age of the house!

Install drawers in existing cabinet or new and cut and fix stone top on the counter cabinet.

We have installed a library ladder to access mezzanine level in the house. However it hangs a little short and is therefore too steep to climb safely. We would like the ladder extended at the bottom with a few extra inches of wood added. It currently has wheels attached to the bottom but these are somewhat redundant so we would like them taken off, the legs extended in matching wood, and protector pads added to the feet to prevent scratching the floor.

Need help assisting and building a wood frame granny flat over next couple of weeks. Any carpentry or building experience very welcome! - Due date: Needs to be done on Wednesday, 25 October 2023

My elderly mother needs cabinets removed from a laundry (it’s one of the laundry cupboard small apartment laundry’s). The cabinets are attached to the wall above the bench and sink and measure 130cm in width. Once removed she has two small floating shelves to be installed above the sink. Also a small clothes dryer needs to be lifted onto the bench and placed on top of a rubber mat. - Due date: Flexible

Repair snapped wood cross bar and fit 2 glass panels (I have)

Hi, I’d like to hire a contractor to make us a custom sliding cabinet to house & display our shop products. The shop is in Fremantle. Rough dimensions: 210cm Length 90cm Width

Looking for a cabinet maker to build storage cupboard for my laundry. - Due date: Before Saturday, 30 April 2022

2 glass cabinets 400x1.6 high (2 small display cabinets) 2 large display cabinets 2,4 length 800 h THE other one is smaller the small cabinets one is 900 long x 700h and the other one IS 1200 x 700 also one peg board 1.8 longx 1.5 high

I have two small tasks. The first is a corner kitchen cabinet door which needs rehanging approx 60cmx 30cm and the foot of a cabinet needs reattaching . Approximately 1 hours work.

Fabricate a timber casement window frame of 600mm x 1200mm. We can install. Would like it done in the next 2 weeks. Also open to a second hand option of a similar size.