Find experienced local carpenters in Hampton East

We have a space under the stairs and looking for someone to build a simple mudroom to include Panelling on a small wall

Part removal of damaged floorboards and replacement following water damage. Re-attach approx 300 x 10 skirting under window. All materials will be supplied (new boards, quads and underlay). You will supply labour, nails/screws and tools. Budget based on $85 per hr 6 hrs - if it takes longer then the hourly rate will apply. If it takes less, I will honour 6 hrs work (i.e. $510)

Sand and Stain Deck Approximately 5.8m long X 4.4m wide Pressure wash, sand and stain preferably

Small laundry renovation. Plastering over a wall to remove some inbuilt shelves. Remove old style laundry tub and replace with cabinet and sink. The cabinet will be in the same location as the laundry tub was for plumbing purposes. Small tiling job around new cabinets. Measurements 164cm wide full wall to be plastered Shelves 107cm wide x 104 high Cabinet space 96cm wide Budget is set for an initial quote

Install new shed into concrete carport. Brand is EasyShed. Please advise if you have experience building this shed before and how many people will work on the job. 3m W x 0.78m D x 2.12H

Put together an Easy Shed, Narrow Slider Garden Shed 2.25x0.75x1.8m.

Kitchen cabinet removal including top plasterboard. Bench top is laminate not stone. Provide the removal charge separately as it’s not required. Offer should list estimated time to complete works.

Build stud wall where sliding doors used to be. This includes removing existing door jam, plastering, put topping compound on and sanding, ready for painting. Dimensions of opening are: 1550mm wide, 2010 height. No materials provided.

Rotten window frame (bottom part) Can send photos

I need a new external entry door to the garage installed. Existing door will need to be removed, have the existing knob/lock taken off, bew door to be installed and painted with a good quality external white paint, and knob/lock placed in. Also require disposal of current door. Details on the new door can be found here: https://www.bowens.com.au/p/corinthian-2040x820x40mm-external-door-halflite-no-7a-exp-primed-clear/ Pictures are attached of the existing door to be removed. You can see that the inside door frame is currently grey, but I would also like this painted white. I will reimburse for all paint prior to job commencement and when receipts are provided.

Extend current Trex composite decking by appx 1900mm x 3600, including posts, beams etc, and adding merbau step (or reusing existing one) Welcome to come and look prior to quoting. Flat ground, easy access.

Insulation of a doggy door at the back door which is wood would like someone that has either skills in Carpenter oh has installed before. Would like a professional job done I have already purchased doggie door . I'm hoping to find someone that I can call for multiple jobs in the future. 🐕🚪 I'm quite flexible with time but would like it done sooner than later.

Need a 70mm wardrobe 'Kicker' with a vent in it. I want to build a wardrobe over existing floor vent - but need vent installed into kicker for air flow. We will then build IKEA Robe on top of built base to result in total kicker height of 140mm.

Looking for a handyman/cabinet maker to help with fitting this oven into the cabinet. The cabinet has two wooden planks placed inside on the bottom that are holding the oven up high. Need help to make these thinner and remove the bottom panel of the cabinet to make the oven fit. The oven currently is the correct size of the cabinet, however there is a gas pipe that is preventing it from being pushed back up the top. The only way for it to fit is to place the oven lower in the cabinet. Need someone creative and capable to help.

This is a Bunnings absco shed - Due date: Flexible

I need the main entrance door painted or stained (whatever you think is best) and the hole on the wall patch. We already tried staining it but it ended up how u can see in the picture (it has been sanded already by another Airtasker but not sure if it needs to be sanded again before being painted or stained (up to you le knowledge. We just need it to look better and as good as possible since our lease it is finishing. It can be done any date at any time before 10th of October which is our vacate date. Thanks. - Due date: Before Tuesday, 10 October 2023

I need the main entrance door painted or stained (whatever you think is best). We already tried staining it but it ended up how u can see in the picture. Thanks - Due date: Before Thursday, 18 May 2023

Need a carpenter or handyman to finish off my deck. Recently removed garden bed that was running along side of deck. Want to put an edge on the deck (see photo) and add a side panels so it can level/step down. - Due date: Flexible

I need a handyman with his own nail gun/tools. We are renovating an old home and need a few tasks complete. Tasks - Replace a couple of wetherboards - t nail new wether boards that have already been pinned on (see photos) - put fast grip fill neatly into all windows on exterior and any other little gaps around house (see photos) - knock off the top of the brick chimney Happy to pay an hourly rate - Due date: Before Sunday, 19 March 2023

I’m looking for quotes on how much it would cost to build a custom room divider, in the wooden slat style. Part of the ‘frame’ will be in front of an existing wall (approx 1000mm) with about 500mm extending beyond the wall. We’d like for the vertical slats that are on the wall to be quite close, but the divider section to be spaced out (1:2 or 1:3). Would need to do some painting and be able to stain/varnish the oak slats. Looking for quote before we decide whether this project is going to go ahead. - Due date: Flexible