Find experienced local carpenters in Hampton VIC

Sand and stain 2 verandahs 1 at front of house and 1 at rear They are both Jarrah wood, tongue and groove Photos below but it’s weathered since those were taken. I had sanded it but never got around to staining so will need to be sanded again

Frame bulkheads to laundry and kitchen.

Table has some heat marking and a couple of light scratches. Needs a light sand and re stain

Need a cabinet make or carpenter to measure, supply and install shelving into 1 existing laundry room cupboard. The space is approx 630 d x 1880 h x 900 w.

Build a fairly simple mud kitchen for our 2 year old. Will need materials. Plenty available on Facebook marketplace place. Like the sinks and bench. I could provide the materials needed.

One panel of the Shed is dinted. It needs to be replaced.

6x3m old deck needs pulled up/ripped out and old decking taken to the tip. Just the covering timber boards need ripped up not the joists or base section. Husband started the job but we’ve run out of time.

Build of kitchen - see photo . No more than $50 as it was only $100 to purchase

This timber lid to the pool cover storage box needs repairing. It has been secured with 6 hinges that will need replacing (or a better alternative)

Put cornice on cabinet top edge and middle wall section between cabinets, total length 5-6m. Supply and install.

I have a new Kaboodle 200mm cabinet from Bunnings that need top, rear and bottom panels trimmed by 5mm, to reduce overall with of unit. Also have 5 draw fronts to be attached.

Shed to be put together from Bunnings need done today

Repair outdoor timber double seat

Installation of water resistant plasterboard sheets onto the timber frame Cutting and fitting boards to size Securing boards to timber frame using appropriate fasteners Taping and jointing seams Apply join compound and sanding for a smooth finish Priming with moisture-resistant sealant

IKEA kitchen Island, 3 units, counter top and front. ENKÖPING Cover panel needs to be cut to size Island needs to be secured to floor Please quote price and expected time to complete. Picture of island provided

I need a wine rack installed in my house it’s floor to ceiling. It’s all in boxes and needs to be fully assembled

Looking for someone to measure, source materials and create a batton and board bedroom feature wall. Width of the wall is approximately 4 metres. Example photo is attached.

We're seeking a quote to remove everything from the kitchen and install budget-friendly kitchen cabinets. We'll provide the oven, dishwasher, canopy, and cooktop.

The manifolds for hydronic heating are hidden behind a wooden drawer/box. This doesn’t allow maintenance of the hydronic system so we need modify lid of the box/drawer so it is moveable ie can be taken off to allow access to manifolds when necessary.

Assemble and install 2 small easy-shed metal sheds 2.25w x 0.78d x 2.12h and 1 x wooden cedar garden shed 1.95w x 0.98d x 1800h fixed to the existing concrete slab