Find experienced local carpenters in Hove

I am wanting to build a bench seat for my dining room. I have started making it but its getting a bit complicated with keeping it level and getting it right. Im pretty sure i already have the materials for the bench seat, just not all the tools to complete it. The last photo is to show how i want the completed seat to sit.

Install new shelves directly to wall for additional storage. 3 shelves, each approximately 540mm x 1200mm. One wall is brick, and the other is a timber frame with plasterboard. Preferably, the shelves should be made of white melamine/MDF. Each shelf ideally could support more than 20 kg.

Installation of footings and reinforced 125mm concrete slab for a Best Sheds double garage 6x7 meters. The ground is level with minimal groundwork needed.

Assemble and install a flat pack Stratco HM8 Handi Mate Shed (approx 3m x 3m) onto a concrete slab (already completed) and bolt down. Door to be left hand side. Some tools available onsite. May be a 2 person job. https://www.stratco.com.au/au/sheds--garages/garden-sheds/handi-mate-garden-sheds/handi-mate-hinged-door/handi-mate-hinged-door-shed-hm8-slate-grey-shmshsdhm8sg/ - Due date: Flexible

Looking for a cabinet maker to make a custom built-in cabinet as described below: To fit into living room wall recess. Wall mounted. W 204cm x H 75cm x D 42cm (approx.). 4 cupboard doors. 2 inner shelves. Design to match existing cabinet (see pics). Colour, white 2-pac to match existing cabinet (see pics). Outlet (hole) for power cord required. Please provide quote/offer. Thanks! - Due date: Flexible

Need a u-install 3-4 drawer unit installed, laminate top and an overhead cupboards, area is only 1m x 1m in an alcove and will complete kitchen, need help prior to ordering because the alcove isn’t 100% square. - Due date: Flexible

The bracket of the front of one of our kitchen drawers broke and the metal drawers side got slightly bent out of shape. (both can hopefully been seen in the photos) I believe it's custom built and I can't seem to find the same bracket to replace it. So I'm guessing the drawers may need to be replaced to fit to reattach the front door again (unless you have any better ideas).

We’ve got a new fridge arriving tomorrow however as our kitchen is 25 years old, the height of the existing cabinets is to low for our new fridge. We’re looking for someone to come and trim the flat kitchen cupboard and doors above the fridge to essentially chop off the bottom 60mm. Pics of old fridge attached. New fridge will be 50mm taller.