Find experienced local carpenters in Lower Plenty

Our fridge does not fit in the current fridge space. We would like the pantry shelves and doors adjusted and moved to the fridge space to make the current pantry the fridge space. In addition we need a drawer removed to make room for a new dishwasher.

We need a large frame fixed and converted into a pinboard. There’s some damage to some of the corners as pictured which ? needs to be clamped and the backing do the frame needs to be secured. I have purchased the materials required for the job - adhesive glue spray and this cork roll: https://www.ecocork.com.au/product/traditional-multipurpose-cork-roll-6mm-thick/ Please make me an offer for the labour to repair this frame and convert into a giant cork board. Located in Lower Plenty.

Hi! I am wanting to DIY some shaker cabinets for my kitchen but don’t have the right tools to cut the timber myself. I need MDF sheet cut down to 72 strips (18 cabinets/drawers) ranging from roughly 150mm - 700mm, in 40mm wide pieces. Happy to supply MDF sheet or reimburse. Thanks

In need of a qualified cabinet maker to make a dual office desk per picture below. Rough dimensions 2600mm x 700mm. Price to be inclusive of all materials, labour and delivery to Lower Plenty. Thanks, Steph

3 sheets of gyprock need to be installed to finish sheeting the entire ceiling, cornice needs to be installed and need to do flushing to entire area it’s a carport 5.1m x 5.8m all materials are on site

Utilise shady area im small terraced garden . Construct wooden safe area rabbit run/ enclosure safe from foxes I already have hutches but can’t leave the poor things caged up . I already have star pickets and wire mesh but am injured and unable to work. Ill defer to your advice and expertise. - Due date: finish asap Before end of January 2024

I have stains of varying degrees on hardwood floor from under pot plants and other reasons. Can anyone sand the stains and polish match the floor?!?! Urgent!! - Due date: Before Tuesday, 5 December 2023

Hi, we are a builder, and we are going to construct a shed beside the house of our client. The site is located in Lower Plenty, VIC. The shed is colourbond with dimension of 18 m x12 m, sitting on a concrete slab. We already have all the shed component on site, so you only need to do the installation works. Can you give us a quote?

Build small garden shed purchased from bunnings. Absco Economy 1.52 x 0.78 x 1.95m Zinc Single Door Garden Shed. The shed has a snap-tite system to avoid screws. There are some screws required, while holes are pre drilled, I'm told you may need a drill just in case. Shed is unopened and in a box. https://www.bunnings.com.au/absco-economy-1-52-x-0-78-x-1-95m-zinc-single-door-garden-shed-with-anchors_p0191307?region_id=116037&gclid=Cj0KCQiAxbefBhDfARIsAL4XLRras9jPwP_0G_Dx4j127HtbpP6J6eKafrrcxFiYQw1ehiEq4N5t85saAjNsEALw_wcB&gclsrc=aw.ds - Due date: Flexible

Need someone to put together 2 x sets of shelves for garage & also build a basketball hoop with stand. All have instructions in the boxes - Due date: Needs to be done on Monday, 13 February 2023

Hi, We have got a cubby that we’d like to put up in the back corner of our garden on a built up landing. The landing has been half built up already with cement and volcanic rock, we just need to extend it to make it a 2m wide x 2m long x 50cm high platform and then create a smooth surface over the top which the cubby can sit on. Please see photo attached. Landscape gardeners, concreters and builders need only apply.

Assemble: 2 x IKEA Billy bookcases with doors (2m tall units) 2 x narrow IKEA Billy bookcases and add doors (2m tall units) Add 2 height extension units to each 2 x IKEA Billy cabinets (1m tall units) Install all and fix to wall Customisation: Each Billy unit will need the back trimmed to allow an additional 2cm for skirting boards Add vertical trim pieces to cover gaps between units, and trim to the bases to create a seamless look - Due date: Flexible

Extend murbau decking. Area is approximately 1.1m x 1.7m. Also replace a small section of rotted fascia board.

removal of old air conditioner rotting boards on carport rebuild hangover area from shed small deck removal of shelf in wardrobe possible pergola build - Due date: Flexible

Looking to get a bbq bench built. We would like this to be a formed concrete. Light colour (almost white). The last image is what we want to achieve. The cabinets and timber will be completed after and not included in this task. Please show previous work before placing offer. Bench will be 3.5m long and about 600mm deep. We will purchase bbq so all measurements will be know. Current area is paved and flat. Attached images show area where couch is - which is where we want the bbq

Hi there I have a patio that is about 18 square meters that I would like to make more cat friendly. I would want to make sure that the cats can go onto the patio but not off into the garden. Please send me through your suggestions and estimates

One to two days work 2 standard sized WIR need to be assembled and installed in lower plenty Drawing will be provided

Installation of garden shed Size 6m x 2.25 Started to put panels together… roof, both sides and the back side of the shed has Been put together so the side with the door still needs to be put together then erected instructions says need 4 people when time to erect

Currently updating our kitchen and require handy man with power tools or a cabinet maker that can cut holes for sink, cooktop and tap in a new ikea bench top. We also need said handy man to install the bench top on to already existing cupboards.

I need someone to assemble a new garden shed. Absco Space Saver: 1.52 x 0.78 x 1.80m. The photos show the shed, and the space I'd like it to go. Due date: Flexible