Find experienced local carpenters in Miranda NSW

Deck is sinking on part of the deck. See photo. Deck is not level on this end. It was sunk by 1 degree

Got some drama with the pre-trader while installing decking. Need a lisensed handyman to help me out this situation before Xmas. Decking area is around 25 sq meters

Put together a flat pack small shed. See photo for tools required

5 doors installed - doors, door jams and architraves Skirting boards installed in small rumpus room, bedroom and small hallway

As shown in the photo, the kitchen benchtop is damaged by the heat in the area of about 6cm and needs to be repaired or replaced. Please send me your quote with the solution proposed.

We have ordered a flatpack Kaboodle laundry for our small 2.7x1.7 laundry. We need the cabinets and benchtop installed. Looking to get this done around the 25th November.

1. Lay the foundation 2. Install the shed

Build decking covering the photo area with a rump on the end for bin storage on the photo.

I’ve got a concrete verandah at the moment. I’d like to put a timber deck over the top of it. The verandah is 6x4m the verandah is all level and flat. I think it’s ready to deck straight on top

Floorboards have lifted need them flattened. Doesn’t need to be perfect just flat! There is no leak. Needs to be done today! No idea how much it costs so please quote

shed assembly plus other small tasks

Looking for reasonable quotes for a pergola to be built in the corner of our garden similar to photo attached. Will also need to include the paving/concrete

Absco Sheds 2.26 x 1.44 x 2.00m Woodland Grey Regent Single Door Garden Shed From bunnings built Two small sand stone bricks need to be removed or smashed (yellow box in photo) so can sit level. Plus one side about 50mm lower to level with conc block or gravel etc.

Looking for a Catio to be installed, roughly 8 - 10 metres long. Something similar to the photo in the ad but with shelter.

Lauft Filing Cabinet document organiser Specifications Materials: MDF Board Colour: Black and White Dimensions: 80 x 32 x 100cm

Looking for someone to design and build this cabinet with easy to slide draws. This is for a quote for half the size of the cabinet pictured and not for the actual work. Please provide in your response: Experience in a similar job Estimated time Estimated cost Location Availability Thank you

Need someone to shave two doors down got new carpet installed which is thick and the bottoms of the doors drag quick easy job

Shelf sheets of MDF of size 230 by 850 Colour white Can pick up the MDF sheet from local store if you quote for service only

Assist me with below - Cut hole in laminate benchtop with jigsaw for cooktop Cut out hole for door/hinge hardware on 1 kaboodle cabinet, other 2 already done. BYO tools, must have a jigsaw Job is for 1 hour total, if it takes longer I’m happy to pay more but should only take 30mins if you have the right tools and know what you’re doing.

We have a section of kitchen cabinet that needs to be widened slightly to accommodate a free standing dishwasher and 60cm oven. No doors need to be replaced, but a new shelf / support / side of the cabinet may need to be cut and installed. Would require an inspection for a quote. Photos attached. Note the old oven has already been removed. We would like to not have to modify the cabinetry above the appliances, and simply cut the cabinet - install new supports and vertical side on the fridge cavity side - with the supporting shelves and that vertical piece bolted to the existing cabinetry / bench top.