Find experienced local carpenters in Morningside

Level Handrails (1 end of hand rail is 2cm lower than the other end). Repair or replace damage balustrades (Some pine balustrades are broken. Others are rotting at the bottom where they contact the bottom rail probably because the ends were not primed properly). Cut off top of balustrade posts to indicated mark. Baluster Handrail Lengths: - 2x 3.6m length - 2x 2.96m length No painting required.

Looking for someone to help me source new kitchen cabinet doors that fit the specifications in the image, so that I can replace the current doors in my kitchen. Ideally you can purchase them too and on charge them to me. I will do the install. Happy to discuss and negotiate on costs.

We are looking for an experienced handyman or cabinet installer to assemble and install IKEA cabinets, as shown in the design image provided. The task involves assembling and securely installing the cabinets in place, including wall-mounted upper cabinets and base cabinets. No stone benchtop installation is required, as this is a cabinet-only job. Requirements: Experience with IKEA cabinet assembly and installation. Own tools for assembly and wall-mounting. Attention to detail for precise alignment and secure installation.

Looking to have an outdoor stair case built similar to picture from verandah to the garden. Approx 7 metres wide. Remove pavers that are there to expose concrete underneath. Remove garden bed and assess if concrete strip needs to be laid to match the other side. I would like a the lower step footing to be on concrete and potentially a concrete strip may need to be laid. See picture for ideas on what we are looking for. Verandah balustrade removed and both sides repaired as the panels are loose or unattached. Can use some of the removed ones to repair the side ones. No painting required.

2 x wooden window repairs required. Water damage/rot. Laundry Room = 99.5cm height x 90cm width. Outside Lower panel right hand side = 45cm wide. Needs repair to outside rotten panel = 35cm wide. Inside panel on right hand side rotten panel = 4.5cm wide. Replace portions or cut rotten and reattach that section? Bathroom Window = 120cm height x 90 width. Both sides lower outside panel needs repairing = 46cm with 34cm insert panel. No painting required.

Cut and install kick boards on two bathroom cabinets. One requires a kick board on the front. One requires a board on the front and one side.

I am making my own hallway table and needing some edging cuts made on some 30mm pine. I can drive to you. Photos show the join I am trying to make. Thankyou!

I need a handyman who has expertise with kitchen cabinet. We need to install a new induction cooktop and an oven underneath it which probably needs to add/remove some parts of the kitchen cabinets. I need a competitive quote please.

New kitchen has been designed and installed. Require someone with joinery or shop fitting experience to fix and install new supplied measured joinery carcass and bench tops together. Nothing a carpenter will also be there to cut the bench tops your job is to purely place in right positions and fix together. Drawings and plans available

Hi all ! We need a square very strong wooden or concrete cover made for pipe access in the backyard Bit hard to describe but please see photos There was a wooden cover there before but the wood has rotten Maybe a hinged door would be good ? Open to suggestions!

I need a timber wall extended/ the return closed off. The wall size is 1m wide by 2.8m high. If a good job there is opportunity for bigger jobs around the house. - Due date: Flexible

I’m looking to have a simple laundry cabinet (similar to the attached photo) built in my bathroom in morningside. I’m not looking for anything fancy - just something simple and practical that looks appealing. - Due date: Flexible

I need some extra timber rails added to block off a void in a loft space (see pictures). We need an extra rail along the long side and the ends blocked off. Ideally one with a small gate. Approximate measurements are (in mm). Long bar front - width (70), height (36), length (2780) Ends - height highest(800), length (400), height lowest (580), width of post (70). Would like them to be done in pine. We will stain. Will need to be done on Wednesdays or Fridays. - Due date: Flexible

I currently have a kitchen island that is too wide for the space. The current island is 2.45m x 0.8m (Picture with dark benchtops). I want instead, to have a narrower island that is curved, preferably 2.45m x 0.65m. I'd also like fluted paneling covering the island eg. Surround by Laminex or Polytec Steccawood Cove, as well as gold trim & kickboard. Examples of what I'm envisaging attached in pictures. I will be organising for new stone to be cut to replace the existing bench tops. The rest of the kitchen doesn't need any work done at this stage. - Due date: Flexible

I would like an outdoor pool towel cabinet built using outdoor timber. Rough dimensions 40cm depth, 90cm length and 80cm height. One side needs to be shelving with a door the other no door and shelving for the towels. See example image - no drawers needed. Must be based in Brisbane for pick up. - Due date: Flexible

I have made wooden boxes and I require these to be attached/screwed to the top of wooden cabinets (1.8m) high. The boxes are already finished. The job will only take 1-2 hours. - Due date: Flexible

15 metres of timber skirting to be installed. Some pieces are already cut to length but had to be removed for recent floor levelling. All timber is on site. Would ideally like this done before new year. - Due date: Flexible

Front wooden external stairs to house are collapsing and stairs need to be replaced. Current construction of stairs is bottom landing/9 stairs/halfway landing/ 6 stairs top landing. Also need approx 8 wooden dowels replaced on the balustrading on the upstair balcony. Willing to pay up to more than allowed $9999 job limit. Budget to be negotiated but up to $16000 - Due date: Flexible

Hi! I'm looking for a quality cabinet maker to design, manufacture and install an outdoor BBQ/Kitchen. We haven't purchased any appliances (BBQ, fridge, sink) so can work these in around the design. The size is roughly be 3000 (L) x 600 (D). Happy to meet to show location and discuss requirements. - Due date: Flexible

I have a new LDV G10+ van that I want to convert to a campervan. Right now it's an empty shell and needs full fitout and electrical. Job can be done at my premises in Morningside as I have a large shed and can help. I want to get started ASAP. Thanks