Find experienced local carpenters in Padbury

Need a corner bench seat made with storage and installation. Photos for reference and link to similar https://www.hgtv.com/design/remodel/kitchen-remodel/how-to-build-a-banquette-seat-with-storage

I recently purchased two couches that need to be brought into my sitting room, but they don’t fit through the door. The couches are quite large and don’t come apart easily, so I’m looking for assistance with disassembling and reassembling them in the room. The dimensions of the couches are as follows: Length: 243 cm Width: 93 cm Seat Height: 47 cm Back Height: 79 cm We are based in Padbury. Could you please provide a quote for this service and let me know your availability? Thank you 😊😊

We need a new pool filter/pump enclosure to built. We had one previously but just installed a new filter, the new gear is too tall for the current enclosure. Enclosure would need to be approximately 1.8m wide, 1.3m-1.4m tall, 1.05m deep (from fence) Ideally have two front opening doors, also be able to open from the top. Colour to match the fence. There is currently the old enclosure still drilled into the pavers below.. ideally allow for mounting the equipment/cables.

Build laundry cabinets to replace old tin sink cabinet. Two double door cabinets required

I'd like to take out the panel in photo and put new wooden frame with panel ready to do wall cladding or similar. Dimension: 3x2.5m

1 tall kitchen cabinet 2 x laundry wall cabinets add suspension rail

I am seeking a quote from someone who can repair/rebuild and fit a wooden kitchen drawer (to replace the old drawer which has rotted out - see photo). The front of the existing drawer and its handles should be re-used so that it matches the other drawers. The sides and bottom of the drawer should be replaced, as the current chipboard type material is falling apart. The new drawer needs to fit in the existing space neat and square, and open and close smoothly. The cabinet itself is likely not perfectly square, but you can use the existing drawer, and your measurements, etc. You will need to have your own registered business, and the required insurances (for example workers compensation and public liability). An invoice will be required. The budget is flexible, please contact me via AirTasker with any questions and send me your quote.

To put up shelves 2 from bunnings & 2 ikea shelves plus 2 rails to go underneath shelves that going up in kitchen. Screws & rawplugs are included. Brick walls

Looking for someone to set out and laser cut on wooden cutting board. I have the board and will need the above done

Looking for someone to build 2x custom colorbond raised garden bed. Colorbond sheets and timber to be cut and assembled. Dimensions are 1500x525x700.

Painting of a front door (inside ) that has been bleach stained

Hi, We need skirting boards sourced and installed in our kitchen. It is a very small space. - Due date: Needs to be done on Thursday, 19 October 2023

Absco 3x2.2 meter shed needs building - Due date: Flexible

- carport concrete levelling We are converting are carport into bedroom the current concrete slap has expansion joints and 60mm out of level. We would like additional concrete poured water proof room and level the floor ready for vinyl plank install. Mes Please see photos for more information. Framework for our doors and gyprock walls are starting to be installed on 28 July so we would like this work done ASAP Measurements of 3200 x 2800 - Due date: Needs to be done on Wednesday, 26 July 2023

Full wardrobe need floor to ceiling -3 full size sliding doors - Due date: Flexible

Looking to install Stainless Steel sheets on wall behind sinks and other area in commercial kitchen. Fabrication/ splash back Pic attached for reference. Can pay for materials as per invoice or you can quote including materials. Approx 25 sqm area - Due date: Flexible

I'd like about 30m2 of Ocean Bluestone (from Freo Stone) to be layed in my pool area. https://www.freostone.com.au/view/bluestone-pavers Keen to get quotes. Ideally early January. Location is Padbury - Due date: Before Monday, 9 January 2023

Needing kitchen cabinet doors and benchtop replaced asap so it can go on the market for sale asap - Due date: Before Sunday, 27 November 2022

We have a new Gable Roof garden shed we need assembled and installed. Currently in boxes with instructions. Very easy job, not a large shed. Area is already prepped and concrete slabs are down ready for installation. Measurements are 3m (w) x 1.5m (d). Need done asap - Due date: Before Friday, 28 October 2022

Had dishwasher installed and need the kicker underneath cut to suit. - Due date: Flexible