Find experienced local carpenters in Sandhurst

We have a shed that needs to be assembled. It is an Easyshed… picture below. It is not very large.

Need my deck sanded and stained before Thursday

I require internal timber divider. 2550ml high x 2000 ml wide x 200ml slats . Black finish, not sure what timer will be used. Could be premade and assembled on site Timber divider will sit flush to ceiling and the the floor. My area is similar to the picture with the lady. Panel will be supported by a left plaster wall , ceiling and floor Only experienced tradies with a reference of previous work . I have no idea of price so starting somewhere Really the black frame no lady last picture

Seeking Airtasker to clean, sand and stain Merbau decking (front, side and back of house). BYO equipment including deck cleaner, scotch tape to cover walls, fence etc Will provide deck stain. All items on the deck will also be moved for you prior to the job commencing. Areas to cover as per the pics provided; • Front decking • Decking at the front & side of the house • Backyard decking including seats Activities involved; • Sweep and pre-rinse areas • Sand decking & Deep clean • Apply Deck clean, scrub then rinse • Apply painter tape to relevant areas • Apply decking stain (2 coats required ) • Post job general clean up Area including deck seats approximately 118m2 Only want trades person with previous experience to apply for this task. Need to start job ASAP weather dependent Due date preferred: Before Friday 30th March 2024

to extent existing 18mm thick benchtop from 60cm width x 48cm deep to 90cm width x 49cm deep. Its an Engineered stone.

Two areas (deck and stairs) need to be cleaned, prepared and 2 coats of decking oil needs to be applied. We'd like to have our front deck area (front porch) cleaned and stained (oiled) Area is around 2.5.x 3m. See attached We can supply the decking oil- but will need you to supply all other materials and equipment Flexible with date and time - Due date: Flexible

I have an external laundry door (820x2040mm) which has water ingressing through the corners of the door. The corner of the door and the door jamb has started to rot. I need someone to come this week and repair/fill the wood and reseal the bottom of door/door jamb. I can repaint afterwards. Door will eventually be replaced but I need a temporary fix that will hopefully last a few years. - Due date: Before Friday, 29 September 2023

Brand new Stratco locker shed needs putting together. Shed is 2.9m x .8 x 1.8m high

To fit new skirting which is already been purchased &,is slightly thicker to the four bedrooms. Please quote. We live in Sandhurst 3977. Old skirting has been removed. - Due date: Flexible

Wanting the doors and end panels put onto our kaboodle kitchen cupboards. 5 x doors

I need a squeaking upstairs floor fixed. The carpet is up. I have tried screwing the particle board subfloor boards down and running diluted PVA along the board edges. This has not worked. I think the problem may be with the joists, so I need a carpenter to take up the floorboard and look at whether the issue is with the joists. - Due date: Before Monday, 13 June 2022

We have just had new carpet installed and now the bedroom and wardrobe doors are too tight and pulling off the paint and carpet. There are: - 3 x bedroom doors - 6 x wardrobe doors - 1 x linen cupboard door We are wanting these removed, trimmed and put back up 😊 we are hoping to get this done as soon as possible as we move in, in a week

We are moving into our new house and wanting to do a few things: - install 2 new windowsills - install new laundry (have some ideas if you’d be able to help 😊) - install cupboards in kitchen (flat pack) - reposition handle on wardrobe door - install door stopper - put up some small shelves in bathrooms Wanting to see if someone could come and quote the work as we’re not sure on cost

Need to widen the kitchen cavity to allow space for a inbuilt microwave. The drawer below can be reduced to accommodate.

Install cupboard shelving 2-3 cupboards. Standard cupboards. Only has a T shape shelves at the moment. I need more shelves for kids cupboards with drawers. Pic 1 is my cupboard and pic 2 is something similar I want to get done.

Require a final coat render to complete outdoor bench top area. 3300mm x 750mm (2 large cut outs) Require surface to be level (close to level) with BBQ insert, roughly 5mm. Only bench top required to be rendered not the front or sides.