Find experienced local carpenters in Springwood NSW

The ash timber slab has slight defects that need filling, The slab is 2.4 meters X 800mm X 33mm. The slab needs to be cut to fit between/ around two 50 x 50mm steel posts. To be set 900mm high against the two steel posts on one side and 2 X 30mm square legs on the other. Overall final dimensions approximately 800mm X 1630mm. Final finish on the timber slab to be clear, not stained darker, therefore the filling of its defects needs to be complimentary to that clear finish.

Shape/cut, sand and seal raw timber chopping boards (1xLarge 2x small). Can pick up and take away to work on and return. They are off cuts from our newly installed kitchen timber bench. They are already the right shape but need plaining on each edge and sanding. I have sealant if needs be. - Due date: Flexible

Need help levelling out the height on kitchen cabinets (already installed) in prep for stone bench top fitting. There are screw feet at bottom of the cabinets. All heights need to be precise within a few mm. A lazer leveller would be handy for this job. - Due date: Needs to be done on Tuesday, 22 November 2022

Half dismantled timber decking and dismantled timber to be removed. - Due date: Flexible

Builder looking for chippy to get a door installed at Springwood. X1 external solid door. Door has been cut to size. Door will need to be picked up from condel Park. Hardware supplied from old door

We need a Carpenter to install 9 new hollow internal doors and hardware. We also need a lock replaced on our front door. We have everything ready to go.