Find experienced local carpenters in Tamborine Mountain

This shed is in a million pieces. Need someone to build it for my parents

Carpenter general maintenance

Needing a small extention built, size approx 3x6. There is an existing roof which will need to be pulled up higher to allow for enough height

Fix the table as per photos

I am looking for someone who can do fibreglass repair to some damage on my septic lid Two sections have been damaged over time

quote to build a 5 metre x 6 metre x 3.5 meter clearance high for a caravan carport

Window installation on our office was done incorrectly, without trim before adding siding. Bottom of window was temporarily sealed using byutel tape (hence the black mess) to cover gap. I need someone with building experience to add window trim over siding (bottom, sides and top) and seal it. Bottom window trim must be angled correctly so water can run off. I should have enough timber to trim the window, or at least bottom and sides. - Due date: Before Thursday, 25 January 2024

Looking for a professional shed builder to buy a DIY double garage shed from BestShed. I have all the materials purchased from BestShed and concrete slab poured ready to go. Shed Size: 6m wide x 6m length x 3m height Location: Tamborine Mountain - Due date: Flexible - Due date: Flexible

Need a plasterer/cornice hand to install 100lm of cornice on a job in tambourine 90mm cove all materials on site ideally a metre rate $5p lm - Due date: Needs to be done on Sunday, 23 July 2023

The existing kitchen hasbeen removed, the new kitchen has ben designed in the original one’s footprint, there is an existing post on the end of the bench which is structural and new kitchen bench has been designed to incorporate the post at the end of the bench and cupboard - Due date: Flexible

Looking for someone with experience to build a standard 6x6m shed from BestShed. Slab is ready and I will supply all the materials. Location at Tamborine Mountain

the section that needs to be replaced is only about 6cms wide by about the same wide the original piece was mahogany it’s a beautiful bed and was in perfect original condition before the move. it’s also been put together unevenly which has twisted the frame. i need someone that is careful and can adjust the fastenings to square and form the bed up. i’ll add pics to show the type of bolts and the damaged section that i’d like replaced. Someone who is good with wood, carving, cabinet making that can match the profile and stain to match please. - Due date: Flexible

I need balustrades/handrails installed on my deck. Looking for basic Queenslander style with cricket stump design. Will pay labor plus materials. You will need to source the materials yourself, bring the receipt and I’ll give you cash for it. There are 9 handrails that will need to be installed. Each around 1.2m in length. - Due date: Before Sunday, 15 January 2023

Hello, needing a handyman or even retiree who can build a very simple partition wall plus install VJ panels on an already existing wall. No painting, just installing. I am able to organise materials to be delivered from bunnings if needed. Thanks - Due date: Needs to be done on Monday, 19 December 2022

Looking for someone who can dismantle our board walk. See images for more info.

I need a carpenter to help me build some simple garden beds tomorrow. Must have own tools. Have had someone pull out last minute. If anyone could help me do this tomorrow that would be amazing should take 1-2 days $65 per hour - Due date: Needs to be done on Thursday, 1 December 2022

Install stratco shed on concrete slab - Due date: Flexible

I have a lot of decking boards that needs sanding so that I can restain it. Unable to sand myself due to hip injury. - Due date: Before Sunday, 16 October 2022

I need an EasyShed Garden Shed put together, it is half assembled as per the pic. And then anchored to an existing slab. (Dynabolts or masonry anchors supplied) 3x2.25m gable shed with swinging doors. - - Due date: Before Friday, 9 September 2022

We have mostly completed the kitchen build with Kaboodle cabinets from Bunnings and solid timber benchtops but need some help with the final fitting of the benchtops (biscuit joins, cutouts for cooktop and sink) and island - Due date: Flexible