Find experienced local carpenters in Toowong

Looking for a carpenter to: 1) look at/replace rotting exterior of wooden home exterior 2) look at supporting the floor of a laundry room which shakes the house(elevated timber floors) during washing-machine spin-cycle (install support jacks?)

The portable aircon comes with a vent that can be fitted into a window frame. The vent dimensions are approximately 165mm wide x 675mm high but the window height is 1470mm. I need someone to source some perspex at the correct dimensions to extend the vent piece the entire height of the window frame. So about 1000mm long and a few mm under 165mm wide. I reckon superglue the perspex to the vent piece at the total length of 1470mm. Plus 2x 1470mm lengths of thin foam (or similar) as padding on the edges to create a seal. I then need it installed in a non-permanent way so that it can be removed for storms and when we finish our lease. I promise it’ll be way less fiddley than it sounds.

2 outdoor verandah’s 2x9m. One treated other untreated. Need sanded and stained

Kitchen cabinet painting, inside and out. Doors, drawers and fixed end panels. Small studio

I need the existing benchtop replaced as its getting quite damaged. I want to put in a new oak finish or similar lightwood benchtop (see photo). It will need to be sealed as it is in a cafe environment.

Fix footing of timber support post which supports some decking above. The metal stirrup has completely rusted through. Also, the concrete slab which the stirrup is concreted into has started to break away from the rest of the slab (only in this corner where the post is). Looking for any solutions to fix this.

Build snd install 2 small cupboards to kitchen and 1 in laundry Price negotiable.

Overland flow from the neighbour's concrete is flowing down our sideway, causing constant dampness and numerous associated affects. We require a proper fix, not just agpipe. Our old permeable concrete house slab may also require treatment. A site inspection is absolutely necessary. My pice guide is not a guide; it's a number to get this entry in the Airtasker system. Please provide some "experience" examples of similar scopes.

I have an open area downstairs, no load bearing structures required . It has also been fully concreted. So no.approvals required total floor space is 10m x4.5m . Will provide sketch . There will be additional framing due 2 recess area. Right now i would like to find someone that i can work with. The price i put it here may be low or high , i have no idea but can be fine tuned

Hi, Need some skirting boards replaced and a corner section that runs vertical up the left hand side of picture replaced. I am looking to carpet at some stage and want these parts fixed. The corners are rubbish and have disintegrated. Need the whole vertical one that goes up from the floor to the roof on the left has come loose and needs replacing (in addition to the corner section). Location is Sherwood Road, Toowong. Happy to have 1 x inspection and then 1 x installation (or all done on one day is fine as well). I want the product to be supplied and installed. I can take handle any rubbish. No need for replacement boards to be painted. 1. The vertical board is roughly 240cm long and 75mm by 44mm. 2. The skirting board on the corners is approximately 90mm x 55mm (each; very small sections on two corners to be replaced). 3. The other section is 35mm + 600mm length of normal skirting board. cheers Patrick

Two items; - remove a sign from its frame/bracket (the sign is affixed to a frame which is mounted to two posts concreted into the ground, the posts and frame are to remain, only the sign itself needs to be take off) - a railing to the front patio has come off at one end, reaffix the railing

I removed a built in wardrobe to replace the ceiling, i need someone to rebuild. 1x white 2700x600 16mm melamine board needs to be replaced. The rest of the material is on site.

Take off 3 old drawers and 1 door and put new ones on already made by cabinet maker. Will need a drill to insert drawer and door handles.

Have vintage/antique wooden chest in need of restoration. Need professional advice to confirm scope, however believe wrap around bottom wood slats (kinda like skirting boards - see photos) may need repairs. Wanting chest stripped back, sanded, and left in more of a raw state (possible sealing of top to prevent damages from spills). May also require wood filling in areas. Full scope pending discussion. Only interested in offers from trades with solid experience doing such restorations.

Bought 2 couches that didn’t fit through the stairwell, needing a few legends to hoist it over the balcony (we are on the first floor) The height from the ground to the top of the balcony is just under 4m

I'm looking for someone to cut a round shaped solid timber. Diameter is 150mm and thickness can be between 15mm to 20mm. And then cut into half. Happy to pick up from you in the Brisbane area.

I have some a desk that needs to be installed and the top put on. Some of the MDF needs trimming to fit the space. I also need knobs puts in the 8 drawers (2 x set of 4 drawers that go on either side).

Offers welcome The job entails removing two old mirrors from two separate bathrooms and installing two IKEA ENHET mirror cabinets. The new cabinets are provided. Dimensions: Width: 60cm Depth: 17cm Height: 75cm

Wooden floor damage (scratches) that needs repair - Due date: Before Friday, 19 January 2024

Remove oil stain from driveway - Due date: Before Wednesday, 10 January 2024