Find a local central lockiing installer in QLD

I have a Mitsubish Express Van. The central locking is no longer working. The engine immobiliser has been disconnected. There is a after market RF Receiver with 2 remotes. This is not working. The button to lock / unlock all doors does not work either. All doors can be individually locked or unlocked with a key but not as a whole. I have tried swapping the main motor in the drivers door but that does not resolve the issue.

Yesterday I removed the rear passenger wheel arch on a ford ranger and some of the wheel arch liner to install a central locking system for a rear canopy. Unfortunately, I didn’t put the wheel arch cover back on correctly and a few of the plastic rivets are broken and I don’t have time to do it again myself today. Need someone to remove the wheel arch cover and check the central locking connection as well as put the panel back on. I can go to Repco and pick up a few replacement rivets if they are needed. If you’ve done this before it should make sense. Unfortunately, as I’m travelling tomorrow, this job needs to be done today so please only respond if you are available thank you.

3 locks wired into central locking Mazda bt50 2023 Locks on canopy have wires on them

Have two utes with canopies that have electric locks fitted - I want these wired into car central locking and also two open door alarms fitted.

Supply and install after market central locking and engine immobiliser. Prefer if my current fobs could also be incorporated but not essential

Supply and install Central Locking System to 2004 Nissan Cube.Model Z11. The current Key activated central locking is in good working orde.

Toyota RegisAce Intermittent remote operation When van first came in was able to register an additional aftermarket remote to the keyless entry module via diagnostic procedure Van left with both original & Aftermarket remotes operating When van came back remotes were not working. Tested replacing the receiver for door control but could not communicate with the new module Suspect issue to be to do with wiring Check earth in white wire which goes directly into door receiver module - it has good grounding. Found white harness plug near door control module had signs of water ingress Plug was difficult to pull apart and once apart found signs of water that had been sitting in bottom part of plug Bottom 4 pins were green with corrosion Tried to clean these pins up and clean with iso When re connecting plugs no response from remotes Suspect issue to be issue with writing near this white harness plug

I just purchased a 2000 Holden Rodeo for work. Great car but the locks on the doors don't work properly. So, I'm wanting to take them out and convert to a remote central locking system (if possible)

MG6 Turbo 2016 batery is draining overnight within 8hrs, central locking system doesnt work and radio turn on by itself. These two are my possible cause of the drain because ever since it happened batery has been draining. But I am no auto electrician so I am not sure. Happy to bring it over to your place to have it checked. Please send me a quote.

I have a '99 Alfa Romeo Spider which came with factory central locking, alarm, and remote. During it's life someone removed the alarm system so now it's just simply central locking which works with the door key. I bought a remote and receiver kit and need someone to do the install so that my central locking can be controlled by remote. I have the full vehicle workshop manual and of course the instructions for the kit itself. From what I've read online it's a fairly straightforward install by accessing the fuse box under the dash (which is easily accessible). I would also like the remote boot release option wired in - the remote has a button for this. Currently the car has a boot release button located in the glovebox so you would need to wire into that feature and maybe also change it to a constant power source as it's currently only active when the key is in the ignition barrel (security feature of kind but it makes no sense!). Please let me know if you have any questions. Happy to share photos of the kit, the car, the fuse box etc. - Due date: Before Friday, 8 March 2024

Supply and install central locking in Toyota hilux workmate 2016 - Due date: Flexible

Inatall remote central locking to 2009 citreon berlingo van. - Due date: Flexible

supply and install central locking for toyota hiace van 2 front doors,sliding door and rear

My car remote is not working with the central locking. The key fob person said it is to do with electrical unit or fuse - Due date: Before Saturday, 11 November 2023

Central locking on my new second hand car isnt working. Only just gor it so not sure what the issue is. Button on key to unlock car doesnt work either. Need everything inspected and repaired or replaced please. - Due date: Flexible

I need a central locking system installed to my landcruiser ute - Due date: Flexible

Installing central locking system - Due date: Flexible

Carryboy canopy central locking wiring into car and brake lights - Due date: Flexible

Central locking on Toyota Corolla 2002 only locks one side with key. Needs to be fixed and or upgraded to keyless central locking. Cheers - Due date: Needs to be done on Thursday, 3 August 2023

Install central locking in a 2005 toyota hilux - Due date: Flexible