Find an experienced concreter in Melbourne

I need a small area of concrete grinding to create some fall on a balcony. Need to grind down from 0 to -15mm The area is 3.9mt wide 1.7mt deap. Need to get the fall toward gutter before water proofing. Area already already cleaned up back to concrete. Old gutter still in place but will be removed, so I can bend this out of your way. Need done asap, all hours or weekend ok. I can help out if need be or just help carry in machine.

Need someone to work with me that lives close to Prahran I do floor grinding and polishing and need a good labourer

Grind and cut concrete pad to match slab level

Needing a stone Mason to cut, lay some bluestone pavers onto bbq area wood box and a narrow piece of marble

Cut concrete where needed Jack hammer and remove brick and concrete porch -Skip required (can be put out front 5 meters away) - porch Size- 5.5m x 1.8m x 0.4m

Concrete block to be demolished from our backyard. 1800 x 1200 x 250. Rubbish can remain onsite.

I will be pouring my retaining wall and need a hand pouring and then trowelling the top edge. All formwork is complete Concrete will be delivered by truck All up 1.8m3 of concrete

Concrete floor chipping and grinding 1sqm area and 20 to 30mm deep. With sloping. Must have complete tools

Cut out One square of concrete Concrete has broken off in parts and cracked already Not all the concrete in this pic one square if it

We need concrete cut, broken up and removed from our backyard. Approximately 22 square metres. There is a side entrance which is roughly 1 metre wide, so it's only accessible with a wheelbarrow.

Cut 2 x small test probes into concrete to help our engineer determine what is there. A problem was revealed following our neighbour engaging a builder to build their own garage/studio adjacent to our garage/studio. A couple of test pits have already been dug up to the edge of our slab which indicate the edge of our slab was partly poured over concrete foundation from boundary wall (wall removed but not the foundation). Our engineer is designing an engineering solution to reinforce the edge of our garage/studio cantilever slab, adjacent to neighbour. Our engineer needs to probe further at 2 separate locations into the concrete to determine the actual edge of our main slab (DIM 1 in the attachment) and confirm the thickness (DIM 2 in the attachment) of main slab. Seeking builder who has skills, experience and tools to cut small amounts of concrete and work under direction of our engineer. (note the test probes *won't* be under a support pillar)

Remove the rock visible, concrete and the concrete that's just below the surface.. in the ground ..plus the metal bits

Formwork is prepped, 0.7m3 concrete ordered for 10 am. Fibre mesh, 25mpa , no reo, just requires placement & finishing . Alleyway access for agi truck. Removable fence panels at back, should be able to chute straight in. Will need to bring wheelbarrow, steel trowel to finish. 1- 2hrs work tops. Arrive 9:30 for mini mix truck booked at 10am Westgarth st northcote

Slab appears to be 4 meters wide. I want to cut it to make room for garden bed.

Help wheelbarrow concrete for small poor (24sqm, 100mm thick) paving slab at noon tomorrow.

Bathroom , Cut trench for new sewer line.

Small area on driveway need concrete grinded down.

Rip up and remove approx 35m concrete path and level out the ground

We need someone to jackhammer and remove the concrete path and edge and bricks along the bluestone from our porch entry of our terrace house. Your offer should include disposal too. Thanks!

7 tubs of rubble, almost entirely mortar, maybe a brick if you're lucky. 45cm x 45cm x 40cm Heavy. Maybe 30kg each. Woud like them gone this weekend.