Find an experienced concreter in South West Perth

Need to demolish brick wall and pillars and limestone retaining wall. This job will need equipment like concrete cutter to remove footing and limestone bricks. The person applying must have the correct equipment to complete the job professionally without causing much damage to the existing pavers.

Impromptu retaining needed before concrete gets poured. Garden beds directly against fence were removed and revealed a much higher fence line than originally thought so we need it retained

Clean up rendering and mortar on wine cellar concrete slab and place on rubbish pile. I can provide buckets, lighting, jack hammer with bolster attachment and wet / dry vacuum.

Down the side of the house looking to get concrete poured. All the way to the back fence. 2M x 27M (the part closest to the camera being wider).

Hi - I have a concrete footing from an old retaining wall I need cut up into small sections so it can be removed. Length is 10m by 300mm wide and the concrete is approx 150mm thick. It can be left in place once cut but just need to ensure the concrete can be moved once cut.

Retaining wall for shed, approximately 6 metres needed. You would need to dig out the existing tin(approximately 1.5m width) and metal stakes that were used as a retaining wall. I can provide the limestone blocks.

The existing Asbestos super six fence will be removed before work commences, and the area excavated ready to lay limestone… Will need 500x350x240 limestone blocks supplied

Just over 1 metre square of aggregate concrete required to be installed.

Prior to site work commencing on our vacant block, we need a section of limestone retaining wall cut and removed from site / disposed. You are welcome to keep or sell on the blocks if desired. Require approximately 2.5m removed, it's 2 courses high plus 1 course of backing blocks. Each block is 1000x350x350. Area surrounding has already been excavated for for access. Price is negotiable.

need a retaining wall built it's 8m total block are about 50-80kg we have blocks just need them installed and concreted we have placed some blocks for reference

3 x 2m front porch i or u to rip out old concrete pad and pour a new aggregate one

Remove thin pavers with crowbar. A trench will be dug separately to this job to aid in building and strengthen a 14.1m long retaining wall with limestone blocks to allow cars to park on a flat bit. The weight is about 75tonnes on it from 14.1*3.7m of dirt and the current wall is 900mm high when you dig down. Do I need one or two blocks of linestone to safely park on it and to strengthen the existing wall? Is there a cheaper way of doing it rather than limestone blocks?

APPROX 10 METRES LONG - 2 COURSES HIGH - 1METRE X 250KG BL0OCKS ALREADY RE-SET AND IN PLACE

Hi All!, Looking to get a small concrete area laid under a patio. approximately 4x3M. Also a small footing for a concrete bbq area

Approx 10m limestone retaining wall. Trench already dug.

Approx 10m length x 20-30cm deep x 20cm thick edge of concrete needs removing down our driveway. Will need large concrete cutting tool. No rebar in the concrete.

Please GENTLY (gas line below) break up nad dispose of concrete slab - do not think there is any reo bar in it at all. 90cm wide side access to backyard Mount pleasant

Require a concrete slab in my backyard - 4 x 2.5 x 0.1m Ground will be prepared. Reinforcement is preferred. No vehicle access. Wheelbarrow only.

About 45 m2 concrete under back side patio.

Slab dimensions: 3,2 m x 2.4 m Concrete quantity: 1.1 cu. m. Concrete quality: To meet Buildingm Code requirements: at least 22 MPa 28 day strength Site will be formed with re-bar mesh in place ready for concrete.