Find an experienced concreter in West Brisbane

Need a garden shed slab with a short path to already existing concrete. Around 11m2 in total. Access via driveway and side gate, as pictured.

Needing two ends of “straight curve” garden edging to be cut 2 x 50mm length cuts Believe an angle grinder would work

My 45 yo brick house sits in Keperra QLD, an area with slightly reactive soil. Subsidence is happening slightly so I would require some foundation underpinning as suggested by the structural engineer, though he noted there's no immediate/short term. I would only consider steel bar/concrete underpinning. Would not consider resin or other cheap band-aid solutions. I put in $5 so we can exchange contacts and discuss. See attached picture so you can provide a rough estimate of quote. Thanks! Not urgent.

Remove 2 x concrete footings plus 2 steel footings plus small piece of concrete. Jackhammer needed.

Concrete Cut slab into manageable size pieces that can be carted away by hand due to no machine access.

Patio 300 cm x 300cm x 10cm slab job. Aggregate concrete. I attached patio and side access gate photos. Also aggregate concrete as a reference. Please give me a quote including labour, material and airtasker fee please. Job should be done from 25 th Oct to 27th Oct.

We need a concrete floor for new chicken coop (which we will be purchasing)Specs below

Driveway widening concrete 1x7m

We need our shed disassembled and the concrete slab that it sits on cut back by 15 cm. The concrete slab is about 2m long.

Looking to get the concrete ground blocks and the concrete wash basin crushed and removed. The concrete ground blocks are roughly 4 inches thick. Hoping to get sorted asap.

7m long and 45cm high retainer block wall. Help to dig the 10cm deep, 30cm wide and 7m long trench and lay and pack 5cm of gravel and retaining blocks. Including gravel fill behind the wall. I am needing help for 8 hours.

Remove existing timber sleeper and posts. About 40 m in total. Lay paver blocks. Around 135 . 400 mm wide x 200 mm high x 200 m deep. Put caps. Use bedding.

Lift the two concrete cracked blocks on driveway, dig out tree root underneath, return the blocks to their original spots. +/- seal cracks with cement. Area approx. 1m2

Besser block wall / seat 2000 x400x400 2 blocks wide x2 blocks high

13 concrete sleepers (in two loads) will need to be lifted on to a trailer so they can be moved down the driveway to where the retaining wall is. Each sleeper then needs to be lifted from the trailer and slotted carefully between C or H beam posts which have been concreted in place. Final preparations to the site are about to be completed and the area will be cleared and ready for the sleepers to be put into place. There are ten 2 metre sleepers which each weigh 72kg and three 1.6 metre sleepers which each weigh 57kg.

Cut up and remove concrete slab. Will require a straight cut down the fence line.

We need this concrete slab to be cut up and removed. Measurements are 2.4 x 3.2 m

Needing a concrete slab laid for an outdoor avairy 2.8 x 4.8 75 deep. Needing a drain or pipe to hose out ASAP.... Apologies for the incorrect initial measurements guys..

My concrete form buckled during the pour and I now require some concrete cutting or grinding to straighten the edge. It is 2000mmL and will require a cut of 20-60mmW and 300mmD. The finish needn’t be perfect but it does need to be straight. There is no steel reinforcement in the area to be cut. I’m not sure what to propose as a budget but am open to offers. Also open to offers on the preferred methodology to remove the material.

Cut entry section of driveway and pour concrete again. Both wings have a cracks. 5.5m x .8m section replacement. - Due date: Flexible