Find professional deck repair services in VIC

Hi all, Could I get a quote to repair the deck? I am not sure what's the best way to fix this. Edit: Updating the budget for folks to provide onsite qutation only. Also please mention in your offer comment approximate cost for final work including labor and material

Large deck in need of some repairs and re-oiling

Timber deck repairs and staining Need to replace the first timber around the pool and one piece at the back of the house. Whole deck to be stained

Need 4 pieces of decking replaced and painted. I have the paint that is needed. 1st piece - 2740 x 1350mm 2nd piece - 4500 x 1350mm 3rd piece - 4500 x 1350mm 4th pens - 4500 x 1350mm If 4500 is too big, we can go with half cuts and keep some of the original decking I believe it is standard deck wood painted on top

- Replaced damaged deck timber Timber width 70mm, height 19mm, length varies - Paint new timber after installation - Check and tighten other deck screws

Revised ad ..19 Jan Timber Deck boards need refixing to the base ..... Re-apply Stain. Please quote for your all labour & all materials. Deck is about 4m x 3.5m We are pensioners, and cannot afford more than this. Please tell us how it can be done for that price or less. Thank You for considering this task.

Painting fascia of single story flat roof house and the deck plus replace a large step on the deck that is rotting.

Some of my decking boards (merbau) need to be replaced. Material can be provided. Need someone to replace the boards that are breaking or rotting

I need the joists repaired on a deck approximately 10m2 area

Wooden deck at rear of house. Need 4 sections to be repaired or replaced due to rot. Tasker to supply timber and bring tools (budget is all inclusive, I have finishing oil). Require repair and finish to match. See attached photos - last one of entire deck for reference.

Outdoor deck touch-up. Deck Cleaning & Sanding, possibly Deck Varnish to withstand rain. *Deck Consultation for possible further repair if necessary. Quote estimates are welcomed. Deck Dimensions: 5.6m x 3.8m 21.28 square meters

Hi, need a quote for replacement of eco deck boards that are damaged on decking

Repair timber deck, fix side gate and hang mirrors

I have a there about 60sq meter verandah and second decking, which needs some repairs but mainly staining. What I want stained: #Floor #Baluster #Turned posts #Beams THE VERANDAH IS MADE OUT OF PINE AND WAS BUILT IN THE 90s. This verandah might need sanding also. Beech forest is 2 1/2 hours from Melbourne this would suit someone locally like Geelong or Colac. BUT SAYING THAT THIS IS A HOLIDAY HOUSE AND ITS POSSIBLE TO STAY THERE TO COMPLETE THE JOB.

Former housemate pressure washed our wooden deck and caused a lot of the wood to chip. We live in a rental so we need to get the deck repaired to the real estate's satisfaction. First photo is from after the pressure washing, second and third photos are from the condition report showing what the deck looked like before we moved in.

I have videos of both decks which explains it more clearly, can send this if needed (airbnb doesn’t allow videos). Two deck repairs: First one is to make some small repairs to the timber supports under this small deck in the front of house. A few of the decking boards have sunk and I believe the timber supports underneath needs to be adjusted. The photo with the arrows shows the area needing fixing. Boards are ecoboards and snap-loc clips are used. I have new decking board and snap-loc clips that can be used. Second one is to add some additional framework to the back deck to fill in where there were plant pots previously. Again I have the deck boards and clips ready to go. Videos explain it better, I can send these.

Small deck extension- must be registered builder

Some stumps need replacing on my deck and repairs around the spa nook in my garden . 17 x 3.1m x 0.70 wide and some other smaller ones . You can see in pictures, I can measure

Deck needs to repaired/ sanded back/ repainted.

Deck needs to be repaired and repainted or varnished. Looking for advice on how to best approach this issue. Happy to negotiate on price for best result.