Find experienced deck builders in Sydney

Dusty balcony needs a good scrub with water jet pressure. - Timber deck - Timber Planter - Timber air conditioner cover - Barbeque - Floor to ceiling glass doors to living room Balcony only measure 6 metres by 3 metres Please bring water jet pressure and chemicals as I have not got any. Swap out gas barbeque

I wanted to have a decking two side partition wall, and front cafe type glass

I have a wooden deck and outdoor bench which is being to fade in colour and would like to have it restained and protected from future sun damage.

Sanding of worn timber to prepare for varnishing.

Looking for a chippy with tools to give us a hand replacing a deck in Erskineville. Please post your hourly rate. Please note we just need an additional hand with the job, we do have tools and materials on site. Appr. duration 4 days all up with a day off during new years day.

Need help to clean and oil my outdoor wooden deck and front door entrance steps. Relatively straightforward job, prob take 4-5 hours with 2 coats. Decking oil to be purchased. Size is 7.5by3m and 1.5by0.5m. see pics

Decking needs to be done on small balcony in a unit in city.

(1)Remove two or three planks on an out door deck. Replace or repair the strut. Replace with original planks. (2) Attach a wood beam behind a gate to prevent it from opening.

Sand back weathered timber deck and re-oil. Deck is 3.2m x 4.8m, with a small step down to grass. Have the oil for the deck - see photo.

Replace outdoor timber decking. Deck frame ok. Timber decking needs to be replaced as they are weathered and old. 3.2m x 4.83m. Current timber slats 90mm wide. Circa 140 linear metres (taking into account the curved shape of the deck) Small step also needs new timber. Open to timber suggestions. Uncovered deck that gets about 6hrs sunlight a day. Budget depends on timber? Open to negotiation.

The deck (approx 20 square metres), including posts and hand rail on one side, needs to be re-oiled with a water-based deck oil (e.g., Cabot’s Aquadeck, can be supplied). The underside of the deck roof/cover, made from painted wooden slats also needs to be cleaned.

I need the existing decking removed. New composite decking and frame purchased and laid. Dims approx 3.6m x 4.2m Initial enquiry at the moment Current planter is demolished

Looking to install the following decking 1. Small area on the side of the house 1x2m - needs to be level. Also want to put up nice panelling to cover up metal fence 2. Replace 2 areas in garden that currently have stones with decking ( 1x 3.5m)

Deck sanded and oiled. 50m2 of sanding and then re-staining Sanding required (not just pressure washing) We will provide staining oil

I want a deck built on top of new level pavers (floating deck). Would prefer composite wood. Need decking supplies and tools to be sourced and provided. As well as installation. It’s only a deck no hand rails, steps or pergolas etc. it will be in a T-shape with the longest side being about 7m and the deepest part about 4m. The top of the T will be about 2m deep. I estimate the total area to be about 27sqm. I need this job done in advance of family arriving on 16th Dec. The address is an oversized unit in Zetland but large elevators give level access to the unit and there is available parking for large trucks and vans to enable delivery of materials. I don’t have particular ideas of cost so open to estimates. Tried my best to add photos of the area (outlined in red in the pics).

Poolside deck needs cleaning and oiling

I power washed my decking to clean it but it has brought up a few splinter issues and needs sanding and painting. I need a quote on the sanding and painting. It’s about 14sq metres of decking to sand and paint

We require someone to lay decking boards for a final small section of our yard. The area is a semi-circle about 4-5m wide and 1.2m deep. We will provide the materials, you will just have to cut it to suit the round shape and lay it down on joists. Joists to be fixed to the slab underneath (concrete slab with tiles over). We think it will be a half day job.

Bring some boards for decking from the depot in Sydney to Tumut. 5400mm long, 600mm Wide and 300mm High, approximately 450 to 500kgs.

Rewire a new head deck for my car, unable to attach harness as wiring has been compromised will need to be rewired. I have the stuff ready to go, need someone with experience in this field to complete my task.