Find local downlights installers in Kellyville

Single floor house, Wiring has to be provided, and Switches can be provided by me

Down light in kitchen went off and not turning on

1) I need 2 additional downlight installed in the kitchen. 2) Wire and Install a new Chandelier ( No existing point ) Notes Downlight is supply and install. Lights need to be aligned straight with existing downlight I will supply Chandelier to be installed. Needs a dual on off switch. I dont want to touchup the ceiling paint. So if possible please advice if this can be done without the need to cut additional holes and patch.

Can you please give me a quote for 1/ installing 4 chandelier type lights / modern lights and 6 down lights 2/replacing with existing ceiling fans with modern ones x 2 No need of new switch, needs to run line from the existing ones One of the chandelier will go to the stair corridor replacing existing down light and another one in normal ceiling height replacing existing down light Thanks

Need to install around 20 downlights and some plugpoints in the wall

Can you please give me a quote for installing 4 chandelier type lights / modern lights and 6 down lights No need of new switch, needs to run line from the existing ones Thanks

15 white led downlights approx 9W.. how much per downlight?

I have 20 downlights, 10 cm width which are required to be installed. 16 downlights on the lower floor and 4 on the upper floor. Wiring and all needs to be done. See images. Lights to be installed - DUSKTEC Recessed Spotlight LED RGB Dimmable 10 W, 230 V LED Spotlights, Colour Changing, Set of 4, 95-110 mm Hole Size Spotlights, Colourful App, Blue

Need help with installation of 12 downlights. 8 in the living room and 4 in the guest room. Please advise on the LED lights wattage as well. - Due date: Before Saturday, 25 November 2023

The sensors which make the downlights of the front porch get switched on automatically seems to not be working since the thunderstorms last weekend. This is causing the lights to get switched on it’s own even during daytime. Need an electrician to look at this tomorrow. - Due date: Before Sunday, 26 February 2023

Installing 4 down lights on existing light points - Due date: Flexible

Hello, I am looking to replace lighting for my entire single story house from legacy bulbs/holders (pic attached) to Downlights. Lights need to be replaced in 4 rooms, Kitchen, 2 Lounges, Dining Area, Alfresco and Hallway. It seems like following: Rooms, Living/Dining Area, Hallway, Alfresco : 40 Downlights Kitchen : 1 Spotlight (set of 3 or 4) I will be happy to supply the Downlights only, and get help for removing the legacy light, installing cabling, installing detachable sockets /plugs for the downlights. The downlights should be easily replaceable if they get faulty. - Due date: Flexible

- installation of 2x down lights - Installation of 1x dining room pendant light - Installation of 2x kitchen pendant lights All materials already sourced - just need installation. Thank you!

Downlight installation needs to be done for ground and 1st floor before that needs to remove the existing light fixture and perform patch work wherever needed after removal.

I need 3 existing fans replaced, using existing power, etc. One on these will be moved outside and two downlights to be added on the back covered verandah. I have already purchased the fans and the lights. - Due date: Flexible

Have the downlights , wires, all needed electricals with me. Need an electrician to install them.

Hello, I am looking for LED downlights installation (approximately 20 downlights with wiring required on ground floor) on a multistory house. Also need few switch board replacement (max 5-6) and pendant lights for kitchen. Need assistance / options/ suggestion to choose lights.

Licensed electrician wanted I need to install a downlight in bulkhead. This includes cutting out a hole for the downlight and connecting it to the downlight next to it for power. I also need to replace a floodlight. See images attached.

Install 2 x down lights in eaves. Wiring to connect to existing wiring already connected to a switch.

Hi, we have installed stratco downlights in our stratco patio and have also left wire for stratco outdoor fan to be connected. We need help with two items: 1) electrical points installed in our roof so that both fan and downlights can be connected and powered on. 2) Mount fan onto the bracket that is on patio already. Here is the link to the fan that needs to be mounted and connected: https://www.stratco.com.au/au/patio--outdoor-living/outdoor-heating--cooling/outdoor-fans/patio-ceiling-fan-led-light-3-blade-obcfl3b/ Here is the link to downlights that need to be connected to power: https://www.stratco.com.au/siteassets/pdfs/patio_outback_lighting_install.pdf Lights are 5w led downlights. Already installed in patio but needs to be connected to power. Three photos are uploaded: 1) led downlight. There are four of them installed. 2) fan mount 3) marking where wire has been left but needs to be connected.