Find a professional downpipe contractor in North West Perth

Removal of old downpipes, supply, and installation of new downpipes

An external drain down pipe needs to be fitted to an existing section of roofing gutter drain (running from top of wall to ground). Pipe work needs to be aded from end of drain to garden area. A strip of edging needs to be cut and fitted to the edge of a tile floor in a doorway.

Hi!! We’ve recently purchased a property needing some renovations. We're looking for a quote to assist with the following. Please note, we haven't inspected the place in person yet, as we’re not based in Perth. The list below is based on photos, inspection reports, and agent recommendations, so there may be adjustments (more/less) once we arrive and can confirm everything. We plan to be there during renovations from Sat 2nd to Mon 18th Nov. It would be great if you could stop by before starting work to ensure we’re aligned and see if there’s anything we may have missed or need to organise! The property is 117 sqm with 3 bedrooms and 1 bathroom. We don't have a floor plan yet, but we'll work on getting one drawn up (no measurements will be included though). * General servicing, checking, and cleaning of gutters. * Some gutters have surface rust. It’s been recommended to apply bitumastic paint to these areas. * There is evidence that the gutters on the east side of the property may have leaked in the past. Potentially: * We’ve been advised to install soakwells for some of the downpipes at least 3 metres away from the property. Is this something you can help with? * We’ve also been advised that the hot water system and air conditioner should ideally be directed into the stormwater system or at least 3 metres away from the building. Is this something you can help with? With your quote, please include relevant certificates/licenses, note any unavailable dates, and an estimate of how long you'll need to complete the work. If you're a jack of all trades, please check out my other listings for more opportunities! Please let me know if you need further info and thank you!!

I need to replace the existing downpipe (90x45) and outlet with a bigger one (100x75).

The downpipes at the property make a lot of noise and dont drain properly due to some being at a 90 degree angle, need to look at changing to a 45 degree angle or alternative to fix the situation

I have built a pergola and need a round down pipe installed. The chippy is unable to install to match our house. It requires 3 bends.

Require quote to replace down-pipe by qualified and insured tech.

Looking for someone to attend my property, inspect and replace down pipes as necessary. Some are in good condition and some are rusted and leaky.

Relocate downpipe to the middle of the house possible down the pole with water going into the garden if it’s safe to do without a soakwell. Using a blue down pipe for the pole

Will be putting a gate attached to wall where the down pipe is. Would like to move around the corner and still maybe use the same soakwell

putting on new exhaust system. all good until reached downpipe. 1 out, 2 are stripped. looking for someone who can get them out without damaging the turbo. 🤝

I’ve had the gutters replaced on my house, but there’s still a section that was replaced, but may need replacing. There is some sag in the roof, so the water pools and would overflow into the eaves. I have punched a few holes in the bottom of the gutter at the lowest point to stop the overflow. I need a section of gutter replaced which is about 1.5-2 meters, and I need a down pipe added to this part to prevent overflow. If the down pipe is not impeded by the rafters where the holes were drilled, then the existing section of gutter could be used. I have none of the equipment, so it will need to be provided. I know the colour of them is Surfmist. I think they may be Fielders gutters, but I want the same style to match the rest of the house either way

I’m looking for quotes to install 2 new down pipes from a second storey townhouse and additionally block off one down pipe. For the new downpipes, one will go down to the ground, the other will empty onto the garage roof. Please see the attached pictures. Picture 1 shows the Down pipe with the red arrow. This is the downpipe to be blocked. It is causing too much water to flow into a 90 degree corner, causing it to spill over into the ceiling of the garage. More photos of the corner in pictures 2 & 3. Picture 4 shows the side of the house, potential locations of one of the new downpipe is in the black stripes. I’m unsure of the best locations to not create a new problem. The last downpipe will go at the front of the house. Ideally you could also add in an “overflow” spout above the downpipe in the corner of the garage ceiling to stop any potential overflow back into the garage.

The roof is leaking into the internal brick cavity. There is no downpipe on the section of guttering.

I have 4 downpipes that appear to be blocked and a kitchen sink that gurgles loudly after using. After use of the sink the overflow relief gully (outside) fills with water and overflows.

x1 Downpipe installed from gutter feeding into soakwell below. Supply and install, color to match existing patio as close as possible

The cuurent downpipes cannot handle the volume of heavy rainfall. Need one more downpipe installed.

One down pipe needing to be replaced

replace twopieces of gutter and install a new downpipe and soak

Require the outside downpipes/balustrades of a small apartment building. Require appropriate preparation and clean-up.