Find local electrical rewiring electricians in Melbourne

We need our LED light re-wired in our bathroom that connects to the switch. We have seeked advice from an electrician on what LED strip we need and have it here. We just need someone to come wire/solder this for us

Replace lighting unit, ballast gone bust, new lighting unit need to be supplied, and rewiring of towel rail switch.

I have a floor lamp I was hoping to have inspected and tested as I suspect the wiring might be faulty. Photos unavailable at the moment but can be provided soon.

I’m looking to have a 20 ft boat rewired with a 12-way blade fuse box mounted and new switch board as the wiring is quite old. The accessories that will need to be wired are as Below. This isn’t a complicated system with a lot of accessories. - New Switch panel - Circuit Breaker - Master switch - Lowrance fish finder - Stereo + 2 speakers - Bilge Pump - lights. Materials all provided . Looking for someone with Electrical experience

I have a lamp purchased overseas that I would really like to change to an Australian powerpoint connections and to double-check that it is wired correctly. Qualified electricians only with warranty of work required.

Hello. I have 3 tasks for a qualified electrician. 1. Rewire Table lamp - needs rewiring throughout whole lamp (not just plug). 2. Remove overhead light 3. Remove power point from kitchen island, and seal off or remove wire leading in to floor - I’m not sure what needs to happen with that to make it safe If you can also patch the ceiling plaster, please include in your quote. Work to happen next week. See photos of each and reach out with any questions. Thanks for your quote.

Outdoor light wiring is busted and needs to be reworked. Hope to install a ring flood camera light in its place.

Rewire lamp, including an inline switch.

A vintage table lamp needs a fairly simple rewiring, to replace its old, broken wiring.

Floor lamp needs rewiring. Severed wires near foot pedal.

2 lamp not working. Have checked bulbs but still not working

I have a 'Bourgie' Table Lamp with wiring that is not working. I need an electrician to fix or rewire it with a dimmer. I am in FITZROY 3065 and very flexible time wise

Need 23 down lights replaced, and 1 new one installed Power points checked, some may need replacement Hardwire smoke detector Open to various quotes, understand it's going to be hard to quote before assessing 2 story town house

I believe that a wire has disconnected itself in my light switch and now they don’t turn off. I need someone to come and wire it correctly

Light switch button is loose, realised the switch mechanism is broken, got a new one, just need a qualified electrician to rewire it to the new switch mechanism.

SCOPE HAS BEEN UPDATED, no longer a full rewire. Electrcian needed this week to; 1. Run 9 circuits from new sub board to kitchen / living room. Holes have been cut in ceiling to check route, will need hole cut through 1 floor joist otherwise route from sub-board to kitchen is clear. Client will repatch holes in ceiling. Circuits are; - 4 power circuits 7m in length - 2 lighting circuits 7m in length - 1 power circuit 13m in length - 1 x 15amp pool heater circuit 13m in length - 1 x 32amp car charger 20m in length to be run but not commissioned (will be done later by others). 2. Run new circuit from sub board and install new IXL tastic in bathroom. Will need to cut hole in wall. 2m run. 3. Install 3 new ceiling fans / lights (fans provided by by client). 4. Install 2 new smoke detectors (supplied by client) 5. Install 1 new GPO with 2m surface conduit. 6. Changeover 10 light switches and 11 GPOs to new faceplates supplied by client. Electrician to supply cabling, surface conduit. client to supply fans, GPOs, light switches and 3in1. Layout and pictures attached. - Due date: Before Thursday, 15 February 2024

I bought an old lamp that needs to be rewired. - Due date: Flexible

Globes are GU10 and the socket is also GU10. Need to install 4 globes and one of the track light wires snapped so needs to be rewired. - Due date: Before Sunday, 28 January 2024

Rewire 2 bedside lamps with AUS outlet plug, new on/off switch in clear plastic wire. - Due date: Flexible

Part 1– REWIRING Upgrade of the wiring would need to be twin and earth from the switch board to each ceiling rose. Neighbours' apartment was done through conduit is in the ceiling allowing new wiring to be pulled through. PART 2 – INSTALLATION install a ceiling fan + reinstall lamps Property is a Mid-Century apartment – bedroom, kitchen, living room, hallway + bath. Street parking available. - Due date: Flexible