Find trusted local electricians in Aintree

Electrical main switchboard trips a lot.

Electrical main switch trips

Need an electrician to put a new switch board, wall mount a TV and hang a couple of pendant lights with new switches/power connection. It's a double storey tiled roof house and all works are on the upper level. TV bracket and pendant lights provided.

4- electric points need install total under 250

i need license electrician that can move position the outdoor power outlet from my alfresco and add another power outlet on the ceiling of my alfresco for future heater

Want a small cupboard to hide nbn Box and cables, with a door.

My air conditioner unit is showing error CH05. I have checked the compressor unit outside and the in line 10 Amp fuse was blown. I replaced it and it blew again after a few minutes of turning the unit back on. Need a professional to diagnose the problem. Location is Aintree 3336

electric fireplace installation required

Need a power point installed in the backyard. On the pergola

TV power point ,chandelier and 3 pendant lights

Flame out on rheem solar water heater with error code 12. Working intermittently and goes down at night

We are planning to install new lights in our house. I need some guidance and installation after discussion

Hi, I am Looking Someone professional , certified electrician to install 4 ceiling fans at my single storey tiled , 3 of the locations has light installed and another one has point and wired TIA - Due date: Before Wednesday, 31 January 2024

We need to get compulsory safety checks done - Due date: Flexible

I have a wired doorbell installed which has stopped working. I have purchased a Google Nest Doorbell. I need a certified electrician who can replace the existing doorbell with the neat Google Nest Doorbell and also with the electric wired setup. - Due date: Flexible

we require a fully registered / licenced electrician as we need a few Items completed throughout our single story home. 1. Install 3 pendent lights over island bench, 2 downlights will need to be removed from this area and reinstalled else ware. 2. Install Chandelier in hallway, this will require a new light switch to be installed (we have not purchased this) 3. Remove 6 x baton lights and replace with downlights (to be purchased) 4. Install 11 downlights in total 5 of which will not have caballing. 5. Install light switch for hallway downlight 6. rewire kitchen lights to a light switch from the back hallway. Note: we have purchased all lights for installation, 2 downlights can be re-purposed however would require electrician to purchase any cabling, extra switches. Due date: Flexible

Want to put hanging pendant lights and some extra GPO points - Due date: Flexible

Seeking a quote to install - 5 power points inside home - plasterboard 1 weatherproof switch in alfresco - brick 4 down-lights in garage ceiling - plasterboard Nothing fancy about the switches, I will buy them from Bunnings and have them ready - so seeking a quote for the skills / labour only. - Due date: Before Saturday, 8 July 2023

Some electrical work, light fittings - Due date: Flexible

Boat Electrical Update Updating the old switch panel to a new one. The old one is corroded and I bought a new switch panel replacement. Basically there are 8 items to wire. Most of the wiring are already existent & don't need to wire from scratch, just need to connect it to the new switch panel. 1. Sounder/Fish Finder - Already has existing wiring, just need to connect to the new switch panel. 2. Anchor Light - Already has existing wiring, just need to connect to the new switch panel 3. Bilge Pump - Already has existing wiring, just need to connect to the new switch panel 4. Deck Wash Pump - Already has existing wiring, just need to connect to the new switch panel 5. VHF Radios 2x - Already has existing wiring, just need to connect to the new switch panel 6. Navigation Lights (green & red) - Already has existing wiring, just need to connect to the new switch panel 7. Deck Lights 12x - Needs to be wired from scratch. No existing wiring. I can screw them into place, and they just need wiring into the new Switch Panel. 8. Battery Isolator - Needs to wire into the battery Box. This is so I can disable ALL connections to the battery when not in use. Please see photos for the wiring diagram. - Due date: Flexible