Find trusted local electricians in Birtinya

Cigarette lighter seems to be powered on all the time need it to come on or off with car ignition

Need the washer door seal replaced. I have the replacement seal. Just need it to be replaced with the old one.

The job is to upgrade power circuits of a restaurant on the Sunshine Coast. The power switchboard is new and has ample room for extension. Add the following power circuits: 1 x 20A circuit over bench @speedoven bench 1 x 15A circuit under bench @speedoven bench 2 x 15A circuit over bench @service counter 1 x 20A circuit under bench @coffee counter 1 x separate circuit for general use (PowerPoints already there, currently 8 is sharing 1 circuit, would like to separate into 2 circuits) 1 x combi oven power extension into existing 3 phase power point Note: new cables can be run along walls (existing cables were installed under the ground)

The GHD is only 1 year old. When turned on a red light and alarm starts to go off every 5 seconds. The straightener will no longer heat up. Google has suggested a fuse has blown and it will need switched back on. - Due date: Flexible

Have to run Cable under some benches in a cafe, on 2 different circuits picking up around 5 appliances per run. Hole-saw some holes in the bench for the appliances also. - Due date: Before Monday, 8 January 2024

Hi there My electric bike does not turn on. The battery is fully charged - Due date: Flexible

55 inch TV needs to be installed on a bracket in the garage. I need an electrical outlet also installed so the TV can have power. I can supply bracket or subby can supply. there looks to be power on the left of the door and on the ceiling to power the garage door. - Due date: Flexible

I would like to install the light outside restaurant. - Due date: Flexible

Attached is a rough wiring diagram of what would be involved for the electrician for power, The office furniture team supply the wall starters, cables and GPO’s required so the electrician needs to install the wall starter, run the cables and plug it all in. The furniture company also supply 3 data (bezels only) per user so the electrician will need to supply and install jacks and cables etc for your data requirements. Also we have a TV to be mounted on the wall (we have the bracket), Also a stick vacuum cleaner holder that needs to be mounted on the wall too. - Due date: Needs to be done on Tuesday, 4 October 2022

I have put together a new Electric Scooter but there are a couple of Bolts that need tightening and I lack the strength and or tools to get them safely done. It is literally just tightening some screws. - Due date: Before Friday, 17th Dec 2021

Installation of 3 wall power points in 2 storey house. GPO to be installed upstairs - access above (loft).

I have set the price low for the task just to list I know and I understand tradesman price offers will come in Please see photos Fix Fluor tube in garage I have new one but still not working I’m a little bit confused.... 1. I took the old tube to the light shop and they gave me a new one so surely it’s the right one and not faulty- however I can take it back for them to check it. 2. I don’t seem to have a starter in under where the tube goes. There is a little thing there but it has no small cylinder in it. 3. I wouldn’t have thought I wouldnt need to replace the whole light fitting as the house is only about 3 years old. 4. Thank you everyone for your comments I appreciate it - please let me know any further advice after reading my comments above - what I should do now or on reading the above if you can advise what the problem is still and even though it’s a new house would it be usual to have to replace a fitting at this time. Also surely the shop didn’t give me the wrong tube, anyhow I can go back and see if it is faulty.