Find trusted local electricians in Campsie

I have an existing freestanding oven that I need to swap over to a new one. New oven is the same as the prior one and existing electrical there.

Hello, I have an Logitech MX Vertical mouse that I need to replace the switches on. See guides linked below. I've sourced the 2 new switches required and mouse skates, but do not have a soldering iron so cannot do the task myself. Therefore I'm looking for some one in the Sydney West area with experience working with small electronics and a soldering iron that can do this for me. I can drop off the mouse and parts to anywhere within 15km of Campsie. https://kaanlabs.com/logitech-mx-vertical-replace-faulty-switches/ https://www.ifixit.com/Guide/Logitech+MX+Vertical+Left+and+Right+Mouse+Button+Microswitch+Replacement/138168

I require an electrician to mount a small wall heater onto the bathroom wall which has tiles and need to change the wall socket from a single to a double

I have a flickering sensor light in front porch Anyone that is experienced in sensor lights & different screw off lighting

Instal 35 iso switch to heat pumps Im Installing and rcd to meter box all material supplied I'll drive there and back accomodation included

Bought a new oven to replace old broken one. Need a licenced electrician to remove old oven and install new one

Repair ceiling light bayonet fitting. It is not working and tripping the circuit when switched on.

Electricity outage. Lights working

Smoke alarm compliance check needs to be completed before tenant moves in

My Solt hear pump dryer has an issue with the water tank. The info panel shows that the water tank is full when it’s not, and then it’s switching off the dryer.

I need a licensed electrician to help with installation of one oyster lamp at my apartment

Hi Tesla home charger to be installed at home!

LED light needs replacement in the living room

I need a power point for the new toilet (Bath 2 pic), a power point for the vertical heated towel rod, a power point for the Vanity cabinet and replace an old power point switch. Pics attached. - Due date: Flexible

replace 2x Oyster LED lights and the faulty light switches. 1. Oyster LED light in the living room not working 2. One of the 4 light switches in the living room very loose 3. Oyster LED light in the bathroom not working - Due date: Flexible

Need two external balcony blinds installed side-by-side. They're electrically operated. Size H 2.4m x W 2.1m each blind - Due date: Before Sunday, 8 October 2023

replace 2x Oyster LED lights and the faulty light switches. 1. Oyster LED light in the living room not working 2. One of the 4 light switches in the living room very loose 3. Oyster LED light in the bathroom not working - Due date: Before Saturday, 7 October 2023

Need electrician for cooktop. Two burners on the cooktop is not working. - Due date: Flexible

Hello - my wife's newish electric water flosser is dead. It would be great if someone could fix it please. If your workshop is near Campsie, Sydney, I'd be happy to bring it to you and pick it up when you're done - Due date: Flexible

I recently had a smart meter installed and an L1 upgraded my fuse box however the line between the 80amp mains fuse and the consumer 64amp breaker is only a 4mm (possibly 6mm - I don’t recall) but is not well suited for running all the required loads such as a car charger at 32 amps along with everything else such as air con, water heater and cooking. The length of cable required to be run is approximately 1 meter. - Due date: Needs to be done on Monday, 19 June 2023