Find trusted local electricians in Corio

Electrician needed to replace a house fuse box. Send your offer please Single story. Located in Corio 3214 Older style fuse box. Have posted pictures of it. Need it updated depending on price. Need a registered electrician to do the work as its main power supply.

Electric recliner does not close properly & seat has dropped.

1 x freestanding lamp (shade fixed and wired so it will work) 1 x robo vac. - wired to plug 1 x recliner chair - rewired and plug connected

I have removed an old ceiling fan and would like to install a light in its place. All wiring is there. Just need someone to fit a new light in that spot. Thanks.

Looking for an electrician who can install an electric hot water system at my rental property in Corio. It’s a small 3 bedroom one bathroom unit size house. Hoping you can help me out as my tenants unit has stopped working properly. - Due date: Flexible

i have 3 aluminum manual shutters i was wanting converted from manual to electric - Due date: Flexible

Pin on the charging point on an LED beauty mask has snapped off and the product no longer works. Still have the broken pin, not sure if this Helps. - Due date: Flexible

Need to remove and install new circuit protection on switchboard as fuse holders and circuit protection do not meet Australian Standards required as per minimum standards and Residential Tenancy Act - Due date: Before Friday, 10 November 2023

I have a new ceiling fan with light I need installed as well as a new light in lounge room just replacing old fitting Not sure of price so just put 100$ - Due date: Needs to be done on Tuesday, 1 August 2023

Need 2 power points installed in the wall side by side - Due date: Flexible

Not sure what I need, currently have old internet connection in the wall looks like a coax cable to me lol I think it's " cable " adsl? internet I don't know but it's a Black cord goes from wall to modem, only one port in the house. No phone line/Ethernet connection. I'm wanting to get better internet but don't think cable internet exist anymore with the port I have ? Not actually sure... - Due date: Flexible

cracked power point in laundry ..needs replacing power to shed in rear run in location not allowed between roof sheet and batten power in shed not protected on rear, needs to be covered or put into mounting block - Due date: Before Thursday, 30 March 2023 - Due date: Flexible

Need to replace old cooktop/oven with a new one. Please see the new cooker below - https://www.thegoodguys.com.au/chef-54cm-ng-gas-upright-cooker-cfg503wbng Cooker has been delivered to the property, just needs to be replaced. Would like to have the old cooker removed as well. Please provide a quote for the job. - Due date: Needs to be done on Friday, 17 March 2023

Would like smart downlights installed throughout the house. In 1 bathroom a ceiling fan and heat lamp/lights. Old light fixtures to be replaced / repaired. Please see house plan attached Approximately 20 downlights. Please quote with downlights supplied and advise length of time to install - Due date: Flexible

Bathroom heat lamp light is blowing the power and happens every time we turn it on - need fixed please. Also, dining room light keeps flashing and buzzing - need fixed also please. - Due date: Flexible

Hi I need a phone line and socket connected as ive just moved house And don’t have one - Due date: Needs to be done on Saturday, 12 November 2022

Electrician wanted to source and install lights and fans. 3 bedroom house. 4 x ceiling fan lights New kitchen light Tastic in bathroom Check overall wiring in house Open to offers This is a rental property. House is currently empty. 49 Granault Needed asap. - Due date: Flexible

I am looking for a electrician who could install a outside light and fix switch in the bathroom - Due date: Needs to be done on Friday, 4 November 2022

Renovating a property so need an Electrician, hopefully Geelong based. Change old bulbs into downlights Heater light in bathroom New rangehood Power for split system External lights - Due date: Flexible

I bought a second hand spa that come with a normal plug, but It trips the Circuit and turns off every 5 minutes so I’m assuming it needs a different cord or my connection isn’t strong enough or something I don’t really understand it but if an elec that know about spas and running the cords and how could fix the issue for me that would be amazing - Due date: Needs to be done on Saturday, 20 August 2022