Find trusted local electricians in Cromer NSW

We already have nbn installed and running. We would like to move the connection box to a different outlet that is located on a different wall within the same room

Electric ceiling fan with remote to be installed in upstairs bedroom

Hi, I need 4 ceiling fans with lights & remote control installed (three in bedrooms, one in dining room) plus 15 outdoor deck lights - please note, all the provisions are done for the outdoor deck lights meaning the cables and powerpoint are done, just need the installation of deck lights. I also need two sensor lights installed (replacing existing fittings/lights).

I need an electric oven (60cm) and cooktop installed. Disconnect the existing electric oven and stovetop.

Fix broken power point and replace hanging lamp from roof. Electricians only.

I have an old lamp that needs to be repaired

Outdoor light Main board circuit work One indoor light Smoke detector

Split air conditioning need to be installed back to back but out side unit needs to be installed on the wall - Due date: Flexible

Need Electrical work to be done on boat Power up the head unit and amplifyer - Due date: Needs to be done on Wednesday, 29 November 2023

Bosch Classic dishwasher. 8 years old. Water does not heat up. I have checked the circuit board and there is nothing burnt out. - Due date: Flexible

Hi, My electric wall oven stopped working suddenly. The grill is still working fine. I'm looking for someone who could repair it. Many thanks, Bruno

I need a licensed NBN electrician to move an NBN port up around a metre so it is hidden behind the TV. - Due date: Flexible

Lamp light will not turn on. Have replaced the bulb and problem still occurs. - Due date: Flexible

Rear view camera and brakesafe system not working on caravan - Due date: Before Monday, 25 April 2022

I need a power point installed in a cupboard. You will need around 2 meters of conduit to run from the other closest power point see picture attached.

Solar power stopped registering on my power bill. Energy Australia not interested , Soltek doesn't answer the phone. I have turmed a knob and flicked a switch, but not sure what is happening

I need to move the indoor unit of my split system airconditioner a meter higher

I've pulled the plate away from the wall when removing an appliance plug.

I have moved into a two story (ground and first floor) brick veneer house in Cromer NSW 2099. There seems to be a new digital antenna on the roof, but no reception located at room points. Job 1: Relocate antenna from the south eastern corner to the south western corner of the house for aesthetic reasons (see attached pic). Job 2: Make sure TV signal is active at relevant points (living room, entertainment room, bedroom) and run cable to add an extra point to Computer room (which is on the ground floor, directly below where the TV antenna will be mounted). … NBN Job 3: I have a good 250Mbps HFC NBN connection. It runs from the pole in the street, to a box on the outside of my wall, to the upstairs study. I would like to change the last part to run it from the box to the downstairs Computer room (directly underneath the study). … Data cabling Job 4: I want to run a Cat6e ethernet cable between the computer room and the living room, and a second one between the computer room and the entertainment room, to take pressure off the WiFi. ... Job will likely require some patching when running cables behind the gyprock. ... Timing: Times that suit include: Friday 14/05/21, or by mutual arrangement. Cheers OB

Our Electrolux Front Loader is showing an E20 message and the machine is struggling to completely drain. In the past I have cleared the drain and it has been aok however am unable to do this myself this time. It would also be good to have the seal around the door replaced. The model is an EFW12832. ideally the job will be completed in before noon of 30 March 2021 (tomorrow). Message me for further information.