Find trusted local electricians in Kambah

roller shutter repair to winding mechanism

Hi There, I am moving overseas next week and am shipping my beloved Desky Desk to my final destination on Monday 29 July. Desky is an Australian brand that makes high quality electric desks. I need someone to disassemble the desk before it is picked up in its parts on Monday 29 July. I paid someone from Airtasker to put the desk together and it took about 90mins. The desk has two parts, the sit stand desk itself (wood surface, electric legs), and the integrated cable and power channel below the desk. I have included links to both more information on the desk. You can click through to the specifications tab and find the manual for both parts of the desk and job. Desk: https://desky.com.au/products/dual-ergo-edge-sit-stand-desk Integrated Cable and Power Channel: https://desky.com.au/products/elsafe-power-board I would prefer you have some sort of experience with this kind of job in the past. Look forward to hearing from you.

Hello, I’m looking for someone to relocate the two power points and data point closer to the floor (same location).

Install light switch on internal garage wall hooked up to 2x 4ft led battens. Power can be taken from existing PowerPoint near garage roller door motor. Garage power connected to RCD inside house.

Looking for an 'off duty' NBN tech to help me pull data cable through underground conduit. 1. I am FTTN with an existing above ground connection 2. I recently went underground with mains power, so whilst we were doing that I got my sparky to run conduit at ~300-400mm+ deep (It varies across the length of the trench) suitable for NBN cable from the pole to the house. There is about 23m of conduit with a cord already fed through and taped off at both end. The conduit has no sharp turns, it's a straight run except for some gradual bends up at either end (sparky did the lot and knew what he was doing, says he does them all the time). 3. The conduit terminates a few feet above the ground, so we may need to connect another 1-2 lengths to properly house the cable once pulled. I am seeking a way around NBNs absurd '$500 simply to quote' process, and do a direct cash job with a tech who knows what they are doing in this space. Airtasker price is nominal at this point, seeking to discuss further with someone to arrive at a fair price. P.S. - I would be seeking you to also provide the cable, or tell me what/where to buy and I can get it myself. EDIT: I want the cable to actually be connected on both ends so my connection with ISP can be reestablished (although happy to complete that task with them if for some reason the change in cable triggers somethin to be done on their end)

I have a lamp. It's electric chord/Switch snapped in half and also had a slight flame when it happened. It can't work any more. I think the electricity chord (not sure what to call it) needs replacing with a new one so I can use the lamp. I am not sure if this can be fixed. I am really wanting to use this lamp as it is not the normal one you can easily replace. I was not sure what price to put on the lamp fixing it up. So its an estimate and I would like some honest feed back. Thank you Kind regards Lisa - Due date: Flexible

install a new outdoor powerpoint, onto the side of house. there is a tv antenna, but doesn’t seem to work and i would like a new connection next to power point outside. - Due date: Flexible

I have an LG. Reverse cycle air conditioner that I would like serviced before summer arrives - Due date: Flexible

Electrian to fix a faulty PowerPoint , replace a pantry light. - Due date: Flexible

Want to install pendant lights above kitchen bench. Already existing lights there so just need to take out and rewire new pendant lights supplied. - Due date: Flexible

We want to replace all existing downlights/flush mounts throughout. We would also like to install 2x new downlights 2x powerpoints 1x upgrade gpo to dgpo 8x exterior deck uplights 1x exterior wall light 5x exterior step light We would also like to remove an existing alarm system which apparently hasn't been used in over ten years. Please quote for installation only as I receive trade pricing on lighting and want to keep the cost down as much as possible. - Due date: Flexible

Van has had intermittent issues with starting past couple of weeks, sometimes fine, sometimes engine is just dead. May be electrical issue related to remote central locking - Due date: Needs to be done on Monday, 17 April 2023

I need to install wifi cables and have to put new 10 downlighting - Due date: Flexible

I have a white power point cover (2 outlets) which I'd like replaced with a black one I bought. - Due date: Flexible

To close off a faulty external security light.

Need electrician urgently for tomorrow morning to fix the power at home. A new fuse has been repplaced by evo energy today and looks like after that we need something else fix to be done by electrician. Not sure about the details muhc. Please come and have a look to fix it.

We are looking for Sparkies, to come and give us a quotes for a newly refurbished kitchen in Kambah. The job is basically 1. Wire and install a set of new downlights, 2. move 3-4 power outlets 3...in addition need Power outlet installed in roof, for the downlights in the eves for the back yard.

Hi need someone to fit an electronic door lock that take codes and keys.

Hi, we need electrician who can move the current position of the fan which is obstructing our newly build wardrobe door. Need to see if there is a way to mvr the fan little far away from the cupboard. Also have other tasks like adjusting the fan hanging sizes other rooms which are too low and we are unable lift hands and worried if any accidents can happen. I am placing a random number we can discuss the details once you come and visit the work to be done. Thank you

Needing someone replace the wall plug on a vacuum Can organise drop off/ pick up to repair location If easier - needs to be completed prior to 26th Jan :)