Find trusted local electricians in Killara NSW

The water heater in the house keeps switching off on its own and we are left without hot water. We need someone to come and fix at a reasonable rate.

Licensed electrician needed to: — install 6 new double power points with a new circuit — relocate by 5cm a light switch — install a new light on side of house to be connected to an existing light switch — install 3 new lights at front of house to be connected to a new common switch House is one storey Owner provides light fittings, power points, switches and light bulbs.

Electrical power points installation in a double brick home

I am having a new wardrobe installed and need the air con wiring moved for the install.

Looking to install four double power points in one of my rooms. Three on the same wall and one on the adjacent wall (brick). Budget is just indicative and I am open to reasonable quotes. Update: I've added a couple of pictures showing the wall and marked a rough location for the power points. On the second photo, there are no existing power points on the wall. The nearest power point in that room is 4.5m away (on the opposite wall) in the direction of the red arrow. There is also a panel of light switches right behind the wall (outside this room).

Hello I need to replace my old electric oven and electric cooktop. I have ordered the new appliances (Bosch Series 2 HBF134EB0A and Bosch Series 2 PKE611CA2A) however my old appliances need to be disconnected and the new applianced installed by a qualified electrician as according to Strata. I am happy to dispose of the old appliances.

we have our TV connected to Fetch TV, the TV is pixelating, the TV works through an NBN modem

I need a few things done around the house: - inspect oven, I think it needs a new element. Light and fan works but no heat. - run a Ethernet cable from one end of the house (where the new NBN router is) to the other end of the house - we need to set up an additional router as the wifi isn’t reaching. - look at our entryway lights (both don’t work) and the intercom and gate switch (also doesn’t work). Some pictures attached.

Install electric door lock

After vacuum and insulation removal of roof cavity we need a safety inspection done of the electrics in the roof cavity before the new insulation is installed. Small house- 110sqm. Old home and want to ensure the electrics are in good working order and safe.

Seeking qualified electrician to fix bayonet lightbulb connector to a hanging light Likely replacement of connector needed. We can send a photo

to check walls for electric wiring path and pipes on walls, to avoid drilling onto those places while placing feature wall with tv unit or fireplace - Due date: Before Monday, 12 February 2024

Existing installed fans need wire connection in 2 rooms - Due date: Flexible

Whole power went off when I pkugged in the charger - Due date: Needs to be done on Monday, 4 December 2023

Manually dig a straight trench (19m long, 600mm deep, 200mm wide) in back yard for electrical conduit. Also dig 4m shallow trench for pool equipment plumbing. Flat block, soil and grass. - Due date: Flexible

Need to change few PowerPoints in wall skirts with smaller size ones . 22 power points need to be replaced Original are 70mm wide , need to be replaced with a 52 mm new ones - Due date: Needs to be done on Thursday, October 5, 2023

Our outdoor clock with hands, always stops with a power outage. Can someone wire it to a power source that is always on even when electricity goes off. - Due date: Flexible

A few quick electrical tasks ahead of joinery installation. All or most of the below will be behind the cupboards after the joinery is complete. 1. Laundry light switch relocated to the other side of the wall. 2. Oven disconnected. 3. Rangehood power cable prepared before joinery installation. 4. 2 existing wall double outlets to be prepared for joinery installation - will be mounted inside cupboards after the joinery is installed. 5. If possible, rewiring an old ventilation fan(B) switch(A) to be used for LED strip(C). - Due date: Before Wednesday, 3 May 2023

In our fully imported toyota car move the speedo or link another speedo to be more visible , put behind steering wheel, and wire another radio volume control to be positioned behind the sterring wheel. The speedo and volune are too far away from the driver. - Due date: Flexible

Change fluorescent light to an oyster lamp at ceiling. Have bought the supplies - Due date: Needs to be done on Thursday, 6 April 2023