Find trusted local electricians in Mascot

See pictures attached It weighs 65kg and there is a power point under allowing the light to be turned on however need a switch to turn it off and on It weighs 65kg so needs few people to lift

Could you please tell me who can uninstall or move the device without charging a fortune

I have two dimmer switches that need to be replaced in my apartment. I have all the parts and supplies. You just need to provide the labour. I expect this to take not more than 15 minutes.

Have recently moved into an apartment, and require some electrical work completed, - 3x Exhaust fans to replace. The three fans I have in the bathrooms and laundry do not seem to extract air, but the motors seem to work, but I think the best option is to get them replaced in case they stop working again. Electrician to supply fans. - Outside building lights not working. The outdoor lights seen in the photo do not work, and I can’t even locate the switch for it, I am unsure if it is connected to the other outdoor light switch that works, if you can get them working, and if lightbulbs are required, will add them in to the total cost. - Bedroom light to move over to the other side, can keep the original light fixture. - 5x dual GPOs to install ( 2x in built in wardrobe, 2x in living room & 1x in bedroom)

I need help connecting / setting up my Internet Router / NBN network. All equipment is already installed into the wall and all cables are already connected. I need the new Service I have bought connected to the existing router / NBN connection box which has been left by previous owners. I have tried to troubleshoot but am not technical. The Router is recognised when searching on existing WIFI, it appears the Internet connection to the new service provider needs to be connected properly for service to work.

I’m looking for a qualified joiner / carpenter to design and build install recess unit for electric fireplace with TV above it. Fireplace is 1300mm wide and 192mm deep (recess will be slightly deeper). This is being installed in an apartment, on wall and has power ready for install. Consulting on design and materials is requested, within scope of job. Pictures provided are my inspiration pictures, however, final job can be tailored based on consultation, and to fit to the budget. Building has lift access, visitor parking plus loading dock with easy access for management of job and material install. I will assign job based on:- - Specific experience in building this type of work, I.e. Electric fireplace and TV walls - Creative solutions and collaboration - Credible ratings and references - Qualifications and relevant work insurances

My 8.5Kg Electrolux front loader washing machine is not dispensing the softener. Will need someone to come have a look. Thank you!

Need a replacement of power point that potentially caused the short circuit to the switchboard. Can do today or tomorrow. Located at Mascot NSW 2020

Hang outdoor light Remove existing power points x 2

We are doing a quick renovation of our 1950s Studio. He need an electrician to: - Remove 2 old pendant lights - Install five recessed downlights - Install a new dimmer switch - decommission an old switch Studio is a single brick construction timber frame and plasterboard inside.

Need to relocate nbn box from bedroom to another area

electricity switch is loose, need to be replaced

I got Bar pressure cleaner machine. While I do plugged in it trips electric main. I need machine to be fixed

the Dryer on and off by it's self.Dunno what the problem is

Electrician needed. Change loose fuse switch in main power board.

Garage roller door requires the following to be fixed please: 1) When the door closes, it touches the ground, then re-opens. Please see photo attached of the motor (Merlin Prolift 430R). There does not appear to be buttons on the motor to adjust the door. 2) Loud squeaking sounds as the door travels on the rails. Please eliminate these sounds. Door travels ok but there is "bump" in the rails where it stutters but then continues moving. 3) Squeaking coming from the top of the roller door. Sounds like springs or something similar. Please also eliminate this sound. Located in Mascot 2020 Thank you so much.

We need all our internal walls sanded and some patching work also. Includes bedroom 1 and 2, lounge, dining and hallway. - Due date: Flexible

We need someone to electrically sand a hallway - Due date: Flexible

A new conduit is required. Needs to go through concrete and a garden bed to the pit - Due date: Before Saturday, 6 January 2024

New pendant lights need to be installed on ceiling. 4 lights in total. Also need to drill at 2 spots in brick wall to hang few paintings. - Due date: Flexible