Find trusted local electricians in Mount Lawley

I have one ceiling fan physically installed but wires not connected. All wires are in the room (not in the ceiling, they are pulled through so no need to go in the roof). Fan has a pull string for on/off so no need to connect to switch. There are 4 wires available from ceiling so will need to test which is correct for fan (previously there was a fan with a light installed). I can borrow a ladder if need be but ideally you can bring one :)

Hi I have a faulty smoke alarm. Have tried to replace battery but still getting chirps

Looking for someone to supply a white suspension kit - one that’s flat like in the pictures - and to uninstall light in picture and install the suspension kit

Our cold pressed juicer has stopped working. Make is an Omega Juicer. The on/off switch doesn't seem to work anymore. I've already started taking screws off to access on/off button but can't get to it.

Hello, I would like a new pond pump installed. It requires re wiring. I will purchase new pump Andrew

I need a quote on 3 new power points indoors

I have purchased 4 exterior lights that I need installed

My power is out, i need to switch my electric gate to manual mode so I can push it manually, but I do not know how. Can someone switch it to manual mode for me?

- extend wall power point in a room - add a wall lighting fixture (with dimming) - add a ceiling lighting fixture (with dimming) - check all smart down lights connection, some flickering. NOTE- ceiling is high, in a heritage home so need to get into ceiling access through manhole by ladder. Looking for registered professional electrician only. If additional work needed/quoted happy to adjust charge as can’t know until out on property. Please get in touch if want this job. Free every day this week until Friday. Thank you

Electrical cord on standing lamp damaged in a couple of places (either side of a switch). Lamp with cord can be taken to a store for repair.

I am having issues with my car battery. I couldn’t start it yesterday there is a clicking noise. Jumper cables helped however this morning i am having the same issue again. I think it can be related to my radio as yesterday it was on and off. - Due date: Needs to be done on Thursday, 18 January 2024

Replace two separate (double plug) power sockets in our kitchen - one does not allow the plug to fully enter (plug cannot sit flush and does not take in power), the other has a broken switch. Must be a licensed electrician. - Due date: Flexible

I need an electrician to install cat6 cable from an nbn box in the garage through the garage roof into the first room of the house (including install of ethernet sockets) - Due date: Needs to be done on Thursday, 2 November 2023

conduit to be installed from the external nbn box to the modem on first level-approximately 15metres -through garage wall -about 10metres - then through kitchen wall - Due date: Needs to be done on Monday, 16 October 2023

I need a old outside small gas water heater disconnected I also need to bring the gas pipe in the roof to come down in living room and connected to our gas heater that we have moved after renovations - Due date: Flexible

Two light globes need replacing over a stair well and are not easily reached. Additionally one of te down lights in te kitchen is faulty and needs fixing/replacing. - Due date: Needs to be done on Friday, 8 September 2023

I have moved into a new apartment and have just had NBN installed. I’m currently working off the WIFI but would like to direct cable the modem to my office, to two power points or even 1 power points with two sockets, using Cat 5 cabling. The office power points are approx 6 metres from the modem but obviously a bit further going via the roof cavity. Either source the Cat 5 cabling or I will provide - negotiable Might also get a ensuite heater light installed as well Maybe just a call out to look first - Due date: Flexible any time that suits

electrician to help with wiring of an existing ceiling light. the light is not turning off and is part of a Clipsal system - Due date: Flexible

Install power point outside - Due date: Flexible

Hi. I have 12 dimmable downlights on 3 separate dimmers, I've swapped from all from Halogen to LED, and some have stopped working, need universal or LED optimised dimmers. Need someone to come in and get it working. I'd prefer not to swap out light fittings, or switch out my dimmable downlights to some other brand or whatever. I'd prefer not to swap out my dimmable switch face plates. You can do whatever you need behind the scenes to get it working. - Due date: Flexible