Find trusted local electricians in NSW

I need assistance repairing the electrical switch button in the bathroom. When pressed, the button usually turns on both the toilet range hood and the light simultaneously. However, it now only activates the range hood and not the light. I have checked the light bulb, and it is working and not faulty, so the issue appears to be with the switch button that does not turn on the light. I live in Watt st Newcastle NSW 2300

11 Ceiling Light Fittings to be replaced (10 are old Alabaster Oyster light) one is standard light globe bayonet) 9 are being replaced with Hue Enrave S (6 are attached to concrete ceiling, 3 to dropped ceiling\plasterboard ceiling if got term right) The remaining two lights are Ledvance Orbis Ultra Slim. Additional tasks looking to have done include: 1. Moving one light switch about 5-10cm to the right. This switch is in brick wall. 2. Install double power point onto kick board, there is a cable behind kickboard already from when kitchen renovated but couldn’t be installed at time as floors were being done. (Double power point already purchased. 3. Replace 6 light switches that have yellowed with identical new ones (already purchased)

breaker not tripped but no power to some outlets

Matrix GTR Fat Tyre Bike - electrical / battery stopped working

Testing and Tagging Electrical equipment.

Laundry is under renovation. Power goes to laundry then outside. Need to re-direct so no power in laundry and stay under house to supply outside. Today if possible. Access under house - about 90cm clearance

Install rheem hot water heater.

Remove existing ceiling lamp and replace with a basic oyster lamp

We have about 8 or so lights that we would like to remove. Painters will patch up.

Change a ceiling mounted light fitting, I have the replacement fitting, similar surface mount.

Install PowerPoint in wall. Existing PowerPoint near by but need this one for behind new dishwasher. Wall easy access as dishwasher not yet installed

Need sparky to wire in a timer for our hot water system. Timer is on hand. Meter box is easy to access. Should be simple 5 minute job. It's a single din rail timer, just clip it on and screw in the wires!

Need 1 light fitting replaced in laundry . Does not need to be the same type . Need 2 new power points for fridges . Please quote to supply and install. There is power near where the 2 power points are to be installed.

Coffee spill on stove top has cut the electricity off in back half of house

repair the staircase lighting, it has a problem with the motion sensor not working. Lights are oyster fittings. Sensor is surface mounted. The fault is either the light or sensor.

We need an electrician to hook up a 3 phase power circuit at the switchboard. Note cable has already been run to an isolation switch at the air conditioner

I have purchased 3 AC ceiling fans with lights and need them installed.

Hi i need 20 down lights installed. Kitchen and living area and external on the eaves. Single storey house. Install only. I will supply the lights and the plug bases and the wiring.